Quick Start Manual

ManualsBrandsBaxi ManualsAppliancesBaxi Platinum Combi HE A

*All installations in England and Wales must be to Local Authority Building Control (LABC) either directly or through a

Competent Persons Scheme. A Building Regulations Compliance

will then be issued to the customer.

www.centralheating.co.uk

This Commissioning Checklist is to be completed in full by the competent person who commissioned the boiler as a means of demonstrating

compliance with the appropriate Building Regulations and then handed to the customer to keep for future reference.

Failure to install and commission according to the manufacturer’s instructions and complete this Benchmark Commissioning Checklist will invalidate the

warranty. This does not affect the customer’s statutory rights.

GAS BOILER SYSTEM COMMISSIONING CHECKLIST

Customer name: Telephone number:

Address:

Boiler make and model:

Boiler serial number:

Commissioned by (PRINT NAME): Gas Safe register number:

Company name: Telephone number:

Company address:

Commissioning date:

CONTROLS (tick the appropriate boxes)

Time and temperature control to heating

Room thermostat and programmer/timer Programmable room thermostat

Load/weather compensation Optimum start control

Time and temperature control to hot water Cylinder thermostat and programmer/timer Combination Boiler

Heating zone valves Fitted Not required

Hot water zone valves Fitted Not required

Thermostatic radiator valves Fitted Not required

Automatic bypass to system Fitted Not required

Boiler interlock Provided

ALL SYSTEMS

’s instructions Yes

What system cleaner was used?

What inhibitor was used? Quantity litres

Yes No

CENTRAL HEATING MODE measure and record:

Gas rate m³/hr OR ft³/hr

Burner operating pressure (if applicable) mbar OR Gas inlet pressure mbar

°C

Central heating return temperature °C

COMBINATION BOILERS ONLY

Is the installation in a hard water area (above 200ppm)? Yes No

Yes No

DOMESTIC HOT WATER MODE Measure and Record:

Gas rate m³/hr OR ft³/hr

Burner operating pressure (at maximum rate) mbar OR Gas inlet pressure at maximum rate mbar

Cold water inlet temperature °C

Hot water has been checked at all outlets Yes Temperature °C

I/min

CONDENSING BOILERS ONLY

The condensate drain has been installed in accordance with the manufacturer’s instructions and/or BS5546/BS6798 Yes

ALL INSTALLATIONS

Record the following:

At max. rate: CO ppm AND CO/CO

Ratio

At min. rate: (where possible) CO ppm AND CO/CO

Ratio

The heating and hot water system complies with the appropriate Building Regulations Yes

The boiler and associated products have been installed and commissioned in accordance with the manufacturer’s instructions Yes

The operation of the boiler and system controls have been demonstrated to and understood by the customer Yes

The manufacturer’s literature, including Benchmark Checklist and Service Record, has been explained and left with the customer Yes

Commissioning Engineer’s Signature

Customer’s Signature