User’s Operating Instructions Baxi Solo 3 PFL Range Wall Mounted Powered Flue Gas Fired Central Heating Units Please keep these instructions in a safe place. If you move house, please hand them over to the next occupier.
Natural Gas Codes of Practice, most recent version should be used Baxi Solo 3 PFL 30 G.C.No. 41 075 20 In GB the following Codes of Practice apply: Standard Scope BS 6891 Gas Installation. BS 5546 Installation of hot water supplies for domestic purposes. BS 5449 Part 1 Forced circulation hot water systems. BS 6798 Installation of gas fired hot water boilers. BS 5440 Part 1 Flues. BS 5440 Part 2 Ventilation. BS 7593 Treatment of water in domestic hot water central heating systems.
1.0 Warnings WARNING: If it is either known or suspected that a fault exists on the appliance, it must not be used until the fault has been corrected by a competent person. Benchmark Commissioning Checklist Please ensure that the installer has fully completed the Benchmark Checklist on the inside back pages of the installation instructions supplied with the product and that you have signed it to say that you have received a full and clear explanation of its operation.
1 2.0 Operating the Boiler 2.1 Operating the Boiler 1. Remove lower door panel as shown (Fig. 1). 2. Turn the boiler thermostat knob to the '0' position fully anti-clockwise (Fig. 2). 2 3. Turn on the main gas and electricity supplies to the appliance. 4. Set the thermostat control knob to the required setting. (The optimum boiler setting depends upon type of system, external controls and your requirements. Your installer will be able to advise you on this matter.
1 3.0 Overheat Cut-Off Device 3.1 Overheat Cut-Off Device 1. Your boiler is fitted with an additional safety device which shuts down the appliance should the system overheat. The "overheat" indicator light will be illuminated if the appliance needs resetting. 2 NOTE: Any interruption to the electricity supply may cause the device to operate. In the case of persistant operation of the device, turn off the boiler and consult your service engineer as an appliance or system fault is indicated. 3 3.
4.0 Clearances 5mm 5mm 5mm during operation 4.1 Clearances around the boiler (Fig. 7) 350mm (30,40,50 models) 462mm (60,70,80 models) 1. The minimum clear spaces needed around the boiler are: 50mm Top: Bottom: Sides: Front: 50mm (2 in) 100mm (4 in) 5mm (3/16 in) 5mm (3/16 in) 600mm 2. These clearances must not be obstructed in any way. Blocking the clearance spaces will result in the appliance overheating and possible damage may occur. 100mm 287mm 300mm for servicing 3.
5.0 Cleaning, Spares 5.1 Cleaning the case 1. The painted panels should be wiped with a damp cloth and then dried completely. DO NOT USE ABRASIVE CLEANING AGENTS. 5.2 Spare Parts 1. Any repairs to the appliance will usually be the responsibility of the Installer during the guarantee period after which spare parts may be obtained through approved Baxi stockists if required. 2. Quote the appliance name, model number and where possible the part number when ordering spares.
Please complete the boxes below 9.0 Warranty & Service Serial Number Standard Warranty Term & Conditions 12 Months Free Warranty - register today To receive your 12 months free warranty please complete the form supplied with the boiler or simply call heateam, the service of Baxi Heating UK Ltd on 0800 013 7990. Our promise to you If you experience a fault with your new boiler, we aim to provide a safe and high quality repair service supported by our dedicated national network of highly skilled engineers.