Assembly

12PCS

8 PCS

4 PCS

12PCS

4 PCS

22PCS

3 PCS

20PCS

4 PCS

2 PCS

20PCS

1 PCS

O 1 PCS

LD RD

CRCL

Attach the runners N to pieces 3 and 5 as shown. Use screws (F).

Attach pieces 3, 4 & 5 using wooden dowel (M) ,screws (D).

PAGE 1
Attach the runners N to pieces 3 and 5 as shown. Use screws (F). 1 12 F 5 6 7 2 9 8 18 3 13 10 10 15 x4 12PCS B C D 8 PCS E F G H 4 PCS I 4 PCS J K L M 2 PCS 4 PCS N O CL DL DR CR F N CL 16 17 14 2 A N CR F 4 3 5 Attach pieces 3, 4 & 5 using wooden dowel (M) ,screws (D).
PAGE 2
3 On piece 8 & 9 attach metal plate (L) using screw (F), put the bar hinges (I) as shown. I 4 Attach the push system base (K) to pieces 1 as shown. Use screws (F). Then put push system (J) on the base. I F F 8 L 9 F F K 1 1 K L K 2 J K 2 F I 1 J 3 I 3 4 J 4 K 5 Attach piece 2 & 6 and assembled 3,4,5 piece to piece 7 using wooden dowels (M), screws (D).
PAGE 3
7 8 Turn the unit upside down, attach piece 10 to piece 7 using screw (H) as shown. Tighten the leg (18) clockwise direction. H 18 H H H H H 10 10 7 10 6 6 9 10 10 Attach pieces 13, 15 & 16 using screws (E). Make sure that the built-in ridge is facing inwards and at the bottom. E 13 16 On piece 14, attach the door handles (O) using screws (G). Slot piece 17 into the ridges. First insert the cam locks (B) into the pre-drilled holes on parts 15 & 16.
PAGE 4
11 Turn the drawer upside down. Line up the holes on the outside pieces with the holes on the runners (NDR &NDL), secure to the drawer using screws (F). 12 Turn the unit upside down, insert the drawers. F F NDL 1 17 16 13 NDR 14 The unit should now be assembled and ready to use.