Owner`s manual

Wall mounting location with the existing
thermostat cable prepared to install the new
Thermostat Keypad.
If the ends of the existing wiring are worn or
broken. Cut off the ends and strip about ¼
inch of insulation from the end of each wire.
Now is a good time to touch up the paint if
needed.
Locate and install the wall anchors and
mounting screws as shown, and described
above.
Connect the Thermostat Keypad to your
thermostat wiring as shown.
Route the slack in the thermostat cable and
wiring back into the wall.
Keep the wire connectors (wire nuts) on the
outside of the wall. They will fit inside the
Thermostat Keypad when attached to the
wall.
Complete installation of the Thermostat
Keypad by sliding it over the anchor screws.
Be careful to not pinch or bunch up the wiring
behind the module.
Adjust the anchor screws as needed to obtain
a tight fit flush to the wall.
11