Installation guide

2-5Remote Annex 4000 Hardware Installation Guide
Chapter 2 Installing the Remote Annex 4000
3 Push the slide mechanism to the left to secure the connection.
Figure 2-3. Connecting Thick Ethernet Cable
Connecting Twisted Pair Ethernet (10BaseT) Cable
Follow the steps in this section to connect Twisted Pair (10BaseT)
Ethernet cable to the Remote Annex 4000 (see
Figure 2-4):
1 Insert the RJ-45 connector located on the Twisted Pair Ethernet cable
into the 10BaseT connector on the rear panel of the Remote Annex.
2 When the connector clicks into place, the connection is secure.