Specifications

16 | Chapter 4: Web-Based Management Interface
Smart Switch Software Manual
Note: The password is case sensitive and with a maximum length of 20.
Switch Menu
There are 4 options available:
• Port Configuration
• Statistics
• VLAN
• Trunking
Switch> Port Configuration Page
You can configure the status per port by clicking a port ID at the port setting menu.
• ID: The port number on the switch. Click this number to configure the port.
• Speed: Indicates the communication mode set for the port. The default setting for all ports
is Auto-negotiation (Auto). The possible entries are Auto-negotiation (Auto), 10 Mbps half
duplex (10M Half), 10 Mbps full duplex (10M Full), 100 Mbps half duplex (100M Half), 100
Mbps full duplex (100M Full), 1000Mbps Full (for port 27 and 28), or Disable.
• Flow Control: Indicates whether Flow Control support is set for on (Enabled) or off
(Disabled). The default setting for all ports is enabled.
• Link Status: Indicates the current speed and duplex for the port. DOWN means no link.
Switch> Port Configuration: Set speed
• Click a port ID.
• Click to select a speed from the pull-down menu under Speed.
• Click Apply to activate the new speed.