Specifications

Chapter 4: Web-Based Management Interface | 19
Smart Switch Software Manual
Switch> VLAN> IEEE802.1Q Tag VLAN
Depending on your model switch there are up to 64 static Tag VLAN groups supported on
your switch. The VLAN tagging option is a standard set by the IEEE to facilitate the spanning
of VLANs across multiple switches (Reference: Appendix A and IEEE Std 802.1Q-1998
Virtual Bridged Local Area Networks).
Click to select IEEE802.1Q VLAN. A screen pops up to confirm this change.
All ports are set belonging to VLAN 1 by default, all untagged.
From the page, you can create a new VLAN, add new ports to an existing VLAN, remove
ports from an existing VLAN or, delete a VLAN.
Add a port to a VLAN Group
• Under the VLAN ID drop down menu, select the VLAN you want to edit.
• Click the box below the port number so that a ‘T’ (tagged) or ‘U’ (untagged) appears.
• Click Apply.
Remove a port from a VLAN Group
• Click the box again until a blank box appears. This will remove VLAN membership from
the port.
• Click Apply.
Note: The default PVID of all ports is 1; therefore, you cannot remove any
ports for the default Tag VLAN. It means that before removing any
desired port from default Tag VLAN, changes PVID of such desired
port to the PVID other than 1.
Create a new VLAN Group
• Under the VLAN ID drop down menu, select Add new VLAN.
• Enter the VLAN ID “2” in the provided fields. VLAN ID must be set within 2 ~ 4094.
• Add VLAN members if so desired; click the box below the port number so that a ‘T’
(tagged) or ‘U’ (untagged) appears.
• Click Apply.
Note: To allow untagged packets to participate in VLAN 2, make sure to
change the Port VLAN Ids (PVID) for the relevant ports. Access the
PVID Settings by using the VLAN ID drop down menu.