SDS

SAFETY DATA SHEET
BAYES TUB AND TILE
Snyder Manufacturing Corporation Page 7 of 7
15.3 EUROPEAN ECONOMIC COMMUNITY INFORMATION:
This product does meet the definition of a hazardous substance or preparation as defined by the European Union Council
Directives 67/548/EEC, 1999/45/EC, 1272/2008/EC and subsequent Directives.
See Section 2 for full Details.
15.4 AUSTRALIAN INFORMATION FOR PRODUCT:
The components of this product are listed on the International Chemical Inventory list.
15.5 JAPANESE INFORMATION FOR PRODUCT:
JAPANESE MINISTER OF INTERNATIONAL TRADE AND INDUSTRY (MITI) STATUS:
The components of this product are not listed as Class I Specified Chemical Substances, Class II Specified Chemical Substances, or
Designated Chemical Substances by the Japanese MITI.
JAPANESE ENCS INVENTORY:
The components of this product are on the ENCS Inventory as indicated in the section on International Chemical Inventories, below.
POISONOUS AND DELETERIOUS SUBSTANCES CONTROL LAW:
No component of this product is a listed Specified Poisonous Substance under the Poisonous and Deleterious Substances Control
Law.
15.6 INTERNATIONAL CHEMICAL INVENTORIES:
Listing of the components on individual country Chemical Inventories is as follows:
Asia-Pac: Listed
Australian Inventory of Chemical Substances (AICS): Listed
Korean Existing Chemicals List (ECL): Listed
Japanese Existing National Inventory of Chemical Substances (ENCS): Listed
Philippines Inventory if Chemicals and Chemical Substances (PICCS): Listed
Swiss Giftliste List of Toxic Substances: Listed
U.S. TSCA: Listed
16. OTHER INFORMATION
PREPARED BY: Paul Eigbrett – (GHS MSDS Compliance PLUS)
DATE OF PRINTING: January 8, 2015
The information contained herein is believed to be accurate but is not warranted to be so. Data and calculations are
based on information furnished by the manufacturer of the product and manufacturers of the components of the
product. Users are advised to confirm in advance of the need that information is current, applicable and suited to the
circumstances of use. Snyder Manufacturing Corporation assumes no responsibility for injury to vendee or third party
person proximately caused by the material if reasonable safety procedures are no adhered to as stipulated in the data
sheet. Furthermore, Snyder Manufacturing Corporation assumes no responsibility for injury caused by abnormal use of
this material even if reasonable safety procedures are followed.
END OF SDS SHEET