Specifications

160, 180, & 184 • Owner’s Manual Supplement Chapter 6: Plumbing
25
Livewell System (184 Only)
Filling & Using the Livewell
1. Insert the end of the drain
stand-pipe into the drain
fitting at the bottom of
the tank.
2. Open the seacock.
3. On the switch panel, turn
On the livewell pump.
See the Locations sec-
tion of this Supplement
for the location of the
livewell pump switch.
The tank should now be filling
with water. If water is not
pumping into the tank, possi-
ble causes are:
• A collapsed hose or clog-
ging debris in the system.
• The seawater intake sea-
cock is Closed.
• The livewell fuse is blown.
To Drain the Livewell
Remove the stand-pipe to
drain the livewell.
FLOODING & SWAMPING HAZARD!
• NEVER leave the boat unattended while the livewell system is running.
• Any leak or break in this system may allow large amounts of water to flood the bilge, which
could swamp the battery(s), and even sink the boat.
• ALWAYS Close the intake seacock when you are done using the livewell system.
WARNING!
!
SYSTEM DAMAGE HAZARD!
Before turning On the livewell system, make sure that the intake seacock is in the Open position
and keep the intake seacock Open until the system is shut Off.
CAUTION
!
AERATOR
PUMP
SEAWATER
INTAKE
LIVEWELL
AERATOR
VALVE
STAND-PIPE
ATTACHED
TO THRU-
HULL DRAIN
STAND-PIPE
REMOVED
NOTE: OVERHEAD VIEW THROUGH DECK
SEACOCK
THRU-HULL
DRAIN