Specifications

160, 180, & 184 • Owner’s Manual Supplement Chapter 7: Deck Equipment
29
180 Bimini Top (If Equipped)
1. Slide the windshield hinges of the main
bow (A) over the aft pre-drilled holes
(B) in the side windshield frames and
insert the securing pins.
2. Unfold the canvas and slide the wind-
shield hinges of the forward braces (C)
over the forward pre-drilled holes (D)
in the side windshield frames and insert
the securing pins.
3. Insert the end eyes of the aft braces (E)
into the deck hinges (F) and insert the
securing pins.
• The jaw slides (G) should not need to be
adjusted.
• If you decide to adjust the jaw slide posi-
tions, obtain the correct measurements
from your selling dealer.
180 Convertible Top (If Equipped)
1. Slide the windshield hinges of the
main bow (A) over the pre-drilled
holes (B) in the side windshield
frames and insert the securing pins.
2. Unfold the canvas top and snap the
front edge of the top to the wind-
shield frame (C).
3. Close the front zipper (D).
4. Pull aft on the aft edge of the can-
vas top (E), making sure the canvas
lies evenly from side to side and
hook the hold down straps (F) to
the deck loops (G).
5. Align the secondary bow (H) with
the center seam (I) of the canvas by
loosening or tightening the top
straps (J).
6. If the canvas top does not have a
smooth, taut look, tighten the hold
down straps by pulling on the strap
buckles (K).
• The jaw slides (L) should not need to
be adjusted.
• If you decide to adjust the jaw slide
positions, obtain the correct mea-
surements from your selling dealer.
• If other canvas (i.e. side curtains or slant back cover) is installed, the canvas top may need adjustment to align the
snaps on the canvas with the snaps on the boat.
SECURING PIN
DECK HINGE
END EYE
G
G
A
C
E
F
B
D
WINDSHIELD SECURING
HINGE PIN
NOTE: YOUR DECK HINGES & JAW SLIDES MAY BE STAINLESS STEEL
A
B
C
D
E
F
G
K
J
H
H
K
L
NOTE: YOUR DECK HINGES & JAW
SLIDES MAY BE STAINLESS STEEL
SECURING
END EYE
WINDSHIELD
HINGE PIN
I