Specifications

Chapter 6: Plumbing 185, 195, 205, & 225 • Owner’s Manual Supplement
36
Livewell System (185 Only) (If Equipped)
Filling & Using the Livewell
1. Open the intake seacock.
2. Push the livewell switch to the fill
position (for the location of the
livewell switch see the Component
Locations section in Chapter 2 of
this supplement).
Troubleshooting
If you followed the instructions in steps
1 and 2 above, but water does not pump
into the tank, possible causes are:
• A hose is collapsed or there is clog-
ging debris in the system.
• The livewell fuse is blown.
Draining the Livewell
1. Close the intake seacock.
2. Pull the livewell switch to the drain
position.
Aeration Tips
The level of aeration is controlled by
the aerator control valve.
• In clean open water little or no aeration may be needed.
• In brackish back waters a higher level of aeration may be needed.
FLOODING and SWAMPING HAZARD!
• NEVER leave your boat unattended while the livewell system is running.
• Any leak or break in this system may allow large amounts of water to flood the bilge, which
could swamp the battery(s), and even sink your boat.
WARNING!
!
SYSTEM DAMAGE HAZARD!
BEFORE turning On the livewell system, make sure the intake seacock is Open.
CAUTION
!