Specifications

Outboard Deckboats • Owner’s Manual Supplement Chapter 6: Plumbing
39
Filling & Using the Livewell
1. Open the intake seacock and, if equipped, the drain seacock.
2. Insert the standpipe into the drain fitting at the bottom of the tank.
3. On the switch panel, turn On the livewell pump switch (for the location of the livewell pump switch, see the
Component Locations section in Chapter 2 of this supplement).
• To drain the livewell remove the standpipe.
Troubleshooting
If you followed the instructions in steps 1 through 3 above, but water is not pumping into the tank, possible
causes are:
• The seacock is Closed.
• A hose is collapsed or there is clogging debris in the system.
• The livewell fuse is blown.