Specifications

Chapter 3: Components & Systems 33

Capri Runabouts • Owner’s Manual Supplement

Canvas Top Installation

1. Attach eye ends of main bow (See point A below) to deck hinges on the boat

and remove boot if necessary.

2. Unfold canvas top and stretch the front edge of the top across the windshield

frame and snap to frame (B). Use care to center the canvas on the windshield.

Close the front zipper (C).

3. Pull back on the top (D), making sure the canvas lies evenly from side to side

and hook the hold down straps (E) to the deck loops located near the rear of the

windshield side wing. If the canvas top does not have a smooth, taut look,

adjust by holding the rear of the top and tightening the straps by pulling on the

strap buckle. When properly adjusted, both sides of the top will be even.

4. Align the secondary bow (F) with the center seam of the canvas by loosening

or tightening the top straps (G). No adjustments to the secondary bow jaw slide

(H) should need to be made as they are preset during manufacturing. Before

attempting to adjust the jawslide position, obtain the correct measurements

from your selling dealer.

5. If additional canvas (i.e. side curtains, slant back cover, or camper cover) are to

be installed, they should be snapped to the top canvas before final adjustment.

The top can then be adjusted as in steps 3 and 4 to bring the lower row of snaps

on the canvas in line with the row on the boat. Like the top, the additional can-

vas pieces are in proper adjustment when they are smooth and taut.