Specifications

Chapter 5: Plumbing 2252 Classic Cruiser • Owner’s Manual Supplement
26
Operating the manual flush marine head:
1. Open the head’s seawater intake valve (seacock).
2. Before using the head, pump enough water into the bowl to wet the sides.
3. After use, pump until the bowl is thoroughly cleaned. Continue pumping a few more times to clean the lines.
4. If excess waste causes the water to rise in the bowl, stop pumping until the water recedes.
Winterizing The Marine Head
1. Shut Off the seawater intake seacock.
2. Pump the water out of the bowl until the bowl is dry.
3. Remove the drain plug in the base and pump again to remove all of the water.
• Do not fill the bowl with anti-freeze.
• Close the intake seacock while the boat is underway or whenever the boat is left moored in the water.
Macerator (If Equipped)
To use the macerator to pump waste directly into the water (where regulations permit):
1. Open the underwater discharge seacock.
2. Press both macerator switches at the same time to run the pump. Do not continue running the macerator if the
waste holding tank is empty.
3. Close the underwater discharge seacock when you are done pumping.
NOTICE
Check with local authorities for regulations regarding the legal use of marine head systems.
HEAD
HOLDING TANK
VENT
WASTE PUMP-OUT
DECK FITTING
HOLDING TANK
SEAWATER PICKUP
& BALL VALVE
MACERATOR
(IF EQUIPPED)
SEAWATER PICKUP
TO MARINE HEAD