Specifications

265 • Owner’s Manual Supplement Chapter 2: Features / Systems
19
Connecting To Shore Power
1. Turn Off all breakers and switches on the AC master panel.
2. Attach the shore power cord to the boat inlet first then to the dockside outlet.
3. Monitor the AC panel’s polarity indicator lights, located below the line master breaker(s), as follows:
• A green
light illuminating after the power cord is plugged into the dockside outlet indicates acceptable electrical
power. You may turn On the master breaker switch.
• A red
light, however, indicates reversed polarity, which could cause electrical system damage and possibly
electrical shock injuries. In this case, do not turn On the master breaker switch (see warning on page 16).
4. Switch the "Line 1 Dockside Master" On.
5. Switch the "Line 2 Dockside Master" On (dual shore power only).
6. Turn On the individual component breakers as required.
DUAL INLET SHORE POWER
INLETS
(IF EQUIPPED)
PORT SIDE
OF DECK
TYPICAL SHORE
POWER INLETS
FIGURE 1
15 AMPS
DUAL SHORE POWER AC PANEL (IF EQUIPPED)
LINE 2
TRANSFER
LINE 1
DOCKSIDE MASTER
15 AMPS
15 AMPS
15 AMPS
10 AMPS
20 AMPS
5 AMPS
25 AMPS
LINE 2
DOCKSIDE MASTER
LINE 1
POLARITY
LIGHT
LINE 2
POLARITY
LIGHT
VOLTMETER
SELECTOR SWITCH
VOLTMETER