Owner`s manual

CHAPTER 2: COMPONENTS/SYSTEMS Ciera 22’ to 28’ Cruisers • Owner’s Manual Supplement
16
Autofloat Switch
If applicable, the autofloat switch
should also be checked often for
proper operation. Lift the float by
turning the plastic insert where the
wires enter the housing, 1/4 turn
counter-clockwise (Fig. 3).
As the float is lifted, the bilge
pump should turn on. If lifting the
float does not turn the pump on,
check the inline fuse. If the fuse is
good but the switch does not work,
it may indicate a bad switch or pos-
sibly a low battery
.
Sleeper Seat Adjustment
Your boat may be equipped with adjustable sleeper seats. These seats can be adjusted fore and aft in the upright posi-
tion. The seat bottoms of these models also adjust into backrests while the seats are in the lounge position.
Fore-aft positions:
To slide a seat forward or backward, lift up on the front edge of the seat bottom
(A). Move the seat forward until the locking mechanism engages in one of the
three different positions. Lift the aft seat at point (B) and slide the aft seat
towards the forward seat.
Lounge positions:
1. To put the seat into the lounge position, lift up on the front edge of the seat
(A) and pull the seat all the way forward. Lift the aft seat at (B) and pull the
aft seat away from the forward seat until the seat is laid out flat.
2. Lift up on the forward or aft seat bottom at point (C) until the seat bottom
drops into the locked position.
3. To lower the seat bottom, lift the seat at points (C) and (D) at the same time.
Drop the seat bottom flat while holding the seat up at point (D).
4. To return the seat to the operating position, lift the seat back at point (E) and
push the seat bottom toward the center of the seat until it locks into place.
FLOAT
PLASTIC
INSERT
DETAIL
OFF POSITION (DOWN)
FLOAT
ON
POSITION (UP)
TYPICAL FLOAT SWITCH
FIG. 3
NOTICE
Discharge of oil, oil waste or fuel into navigable waters is prohibited by law. Violators are
subject to legal action by the local authorities.