Specifications

8 Chapter 2: Features & Systems
Ciera 2655 Sunbridge • Owner’s Manual Supplement
Boat Lifting
• Always follow the lift equipment’s instructions and requirements.
• If bilge water is present, pump water out of the bilge areas before lifting your boat. Excessive amounts of bilge
water can shift and change the balance of the load.
• When lifting your boat, always position the lifting slings at the fore and aft sling label positions.
Anchor Windlass (Available Through US Marine Parts)
An anchor windlass is available through
US Marine parts. Read the manufac-
turer’s instruction manual, before using
the anchor windlass for the first time.
• The windlass can be controlled from a
switch at the helm or from the deck
foot switches.
• Verify that the windlass breaker is
activated before using the anchor
windlass.
• To haul the anchor, use engine power
(not the windlass) to move the boat to,
and directly above, the anchor. Acti-
vate the windlass to disengage the
anchor from the bottom by pulling it
straight up.
CAUTION!
PRODUCT OR PROPERTY DAMAGE HAZARD!
When lifting any boat always use a spreader bar. The spreader bar must be equal to the width
of the boat at the lifting point. Always secure the slings to one another to prevent the forward
sling from sliding up along the forefoot of the boat.
!
3 1/2" 42 1/2"
F
O
R
E
F
O
O
T
TYPICAL TWO
LABELS PER SIDE
Lifting sling positions shown on this drawing
are typical for port and starboard sides.
VIEW OF FOREDECK
ROPE
CHOCK
NAVIGATIONAL
LIGHT (TYPICAL)
WINCH “DOWN”
SWITCH (TYPICAL)
ANCHOR
WINDLASS
ANCHOR ROLLER
FWD.
(TYPICAL)
WINCH “UP”
SWITCH (TYPICAL)
CAUTION!
PRODUCT DAMAGE HAZARD! Do not pull the boat to the anchor using the windlass or continue to
operate the windlass if it has stalled or is overloaded.
!