Owner’s Manual

ManualsBrandsBayou Breeze ManualsOutdoor & Patio FurnitureEnprise Fire Pit 3 Piece Bistro Set

Owner’s Manual

3PC WICKER BISTRO SET

WARNING

Improper installation, adjustment, alteration, service or maintenance can cause injury or

property damage. Read the owner’s manual thoroughly before installing or servicing this

result causing property damage, personal injury or loss of life.

DANGER

WARNING

If you smell gas:

1. Shut off gas to the appliance.

3. If odor continues, keep away from

the appliance and immediately call

e department.

Do not store or use gasoline or other

vicinity of this or any other appliance.

An LP-cylinder not connected for use

shall not be stored in the vicinity of

this or any other appliance.

For outdoor use only.

Save these instructions for future use. If

you are assembling this unit for someone

else, give this manual to him or her to read

and save for the future.

Summary of content (15 pages)

PAGE 1
3PC WICKER BISTRO SET DANGER If you smell gas: 1. Shut off gas to the appliance. 3. If odor continues, keep away from the appliance and immediately call e department. WARNING Do not store or use gasoline or other vicinity of this or any other appliance. An LP-cylinder not connected for use shall not be stored in the vicinity of this or any other appliance. WARNING For outdoor use only. WARNING Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage.
PAGE 2
SAFETY INFORMATION Before you assemble or operate this unit, please carefully read this entire manual. Failure to do so may r WARNING • The installation of this unit must adhere to local codes or either the National Fuel Gas Code, ANSI Z223. 1/NFPA54, OR CAN/CGA-B149.1, National Gas and Propane Installation Code. • THIS UNIT IS INTENDED FOR OUTDOOR USE ONLY! This product shall be used outdoors, in a ventilated space and shall not be used in any enclosed area.
PAGE 3
• Combustible material should not be within 72 inches of the top of the unit, or within 48 inches around the entire unit. • Keep the appliance area clear and free from combustible material, gasoline and other flammable vapors and liquids. • If the flame goes out while burning, turn the gas valve off. Wait 5 minutes before repeating the initial lighting procedure. Once you have a flame started, hold down the control knob for 1 minute. • Do not add water into the unit.
PAGE 4
PAGE 5
CONTENTS Item A B C D E F G H I J K L M N O Description Burner Lid Table Top Side Panel Front Panel Lava Rocks Back Panel Protective Cover Door Metal Stand Battery (AAA) Guard (Pre-assembled) Burner (Pre-assembled) Fire Bowl (Pre-assembled) Control Knob (Pre-assembled) Electronic Ignitor (Pre-assembled) Qty 1 1 1 1 1 Box 1 1 1 1 1 1 1 1 1 1 Page 5
PAGE 6
ASSEMBLY INSTRUCTIONS 1. Check that the control knob (N) for the gas supply system is turned to the “OFF” position before starting any assembly. 2. Attach the side panel (C) and door (H) to the table top (B) using four M6x15 screws (BB), four washers (EE) , four screw caps (AA). 3. Attach the back panel (F) and front panel (D) to the side panel (C) and door (H) using eight M6x30 screws (DD),eight washers (EE), eight screw caps (AA).
PAGE 7
4. Attach the metal stand (I) to the bottom of front panel (D) and back panel (F) using four M6x25 screws (CC), four washers (EE), four screw caps (AA). 5. With the help of another person, turn the table in upright position. 6. Attach hose of regulator tightly to the bracket.
PAGE 8
ASSEMBLY INSTRUCTIONS 7. Place propane gas tank (not included) into the metal stand ( I ). Make sure the gas tank sits on the metal stand ( I ) completely. Turn the preassembled wing screw on the outer part of metal stand ( I ) clockwise to secure the propane gas tank tightly. 8. Turn the cylinder valve on the tank clockwise to close the propane tank. Attach the preassembled regulator from the table top (B) to the cylinder valve by turning the regulator coupling nut clockwise.
PAGE 9
10.Pour the box of lava rocks (E) into the firebowl (M). CAUTION To ensure proper function, the guard (K) on this burner (L) should be free of lava rocks at all times.
PAGE 10
OPERATION Before performing a leak test, be sure that no sparks can occur and you are in a spacious outdoor area. Connect the propane gas tank to the regulator and turn the valve on the unit to the “off” position. Brush a soap and water mixture on all connections. Turn the gas supply on; if bubbles occur on any connection there may be a leak. If you smell gas or a leak is discovered turn the gas valve off, disconnect propane gas tank and do not use the appliance until the leak is repaired.
PAGE 11
MAINTENANCE • Before performing any maintenance always disconnect propane gas tank. • Keep the heating item free and clear from combustible materials. • Visually inspect burner for obstructions and keep tank enclosure free and clear from debris. • Use a soft brush to get rid of the mild stains, loose dirt and soil after the burner and pumice stones/ lava rocks/LavaGlass® are completely cooled down. Wipe down with a soft cloth.
PAGE 12
TROUBLESHOOTING
PAGE 13
CHAIR-PARTS DESCRIPTION M6x40 Screw Seat AA A 10 2 Washer 10 BB Base Screw Cap 2 B CC 10 Hex bolt driver DD 2 Cushion C 2 Page 13
PAGE 14
CHAIR ASSEMBLY INSTRUCTIONS 1.Assemble the seat (A) with the base (B), insert the front leg tubes into the front arm tubes. 2.Tighten the seat (A) with the base (B) using hex bolt driver (DD),five M6x40 screws (AA), five washers (BB), five screw caps (CC).Repeat the same assembly for other chairs. 3.Place the cushion (C) on the seat (A).
PAGE 15
WARRANTY CONTACT