Instructions / Assembly

11
CONNECTING REGULATOR HOSE ASSEMBLY TO COOKER
The Regulator Hose Assembly is a pre-assembled unit. Do not take apart. Simply connect the regulator hose assembly to the LP
gas cylinder and to the cooker. An adjustable wrench is needed when attaching the hose to the SP10/SS10/SQ84/SS84 Burner
or SP1/SS1 Orifice Bar.
Visually inspect the regulator hose assembly prior to each use. If there is evidence of abrasion, wear, cuts or leaks, the hose
must be replaced prior to the appliance being put into operation.
#SP10/SS10 or #SQ84/SS84 Cooker - Attach hose connector to burner in one of
two ways as shown below.
Turn Air Control Shutter to
adjust flame quality
Turn CLOCKWISE
Wrench Tighten
OR
Turn CLOCKWISE
Wrench Tighten
Turn Air Control Shutter to
adjust flame quality
Place large end of spring
against Air Control Shutter
Screws may need tightening
DO NOT over tighten!
#SP1/SS1 Jet Cooker - Attach hose connector to orifice bar as shown below.
IMPORTANT:
Must be able to turn
Air Control Shutter...
DO NOT over tighten!
Turn CLOCKWISE
Wrench Tighten
Orifice Bar
from SP1/SS1 Jet Cooker
WARNING
Insure the cylinder valve is CLOSED (valve turned clockwise) prior to connecting the LP gas cylinder to your
cooker. Turn brass valve on the regulator clockwise to properly close the flow of gas. Read and follow all
instructions and warnings on the supply hose safety tags. Read and follow all warnings in this manual
concerning the safe use of LP gas cylinders and the regulator hose assembly, before connecting cylinder to
cooker. Read and follow all warnings on the LP gas cylinder.
Turn Coupling Nut
CLOCKWISE
to Attach
Hand Tighten!
Turn Brass Valve
CLOCKWISE
to OFF position
Upright
position
1. Check that cylinder is upright and the valve is closed by turning
the knob clockwise.
2. Remove the protective safety cap from the cylinder valve and the
Type-1 Coupling Nut on the regulator
3. Insert the nipple of the large coupling nut into cylinder valve outlet.
Insure that the coupling nut is centered properly.
4. Turn the large coupling nut clockwise by hand and tighten
to a full stop. Take care not to cross thread the coupling nut
onto the cylinder valve. Do not use tools to tighten connection.
NOTE: If you are unable to make the connection,
repeat steps 3 and 4.
5. Check that the hose does not contain kinks, does not come into contact with sharp edges, and does not contact surfaces
that may become hot during use.
6. Leak check all fittings before lighting cooker. See section on "Gas Leak Test Instructions" on page 12.
CONNECTING REGULATOR HOSE ASSEMBLY TO LP GAS CYLINDER