Instructions / Assembly

ManualsBrandsBayou Classic ManualsGrill Accessories16 gal. Stainless Steel Brew Cooker

GAS SUPPLY HOSE

Watch for Bubbles

SP10/SS10

SQ84/SS84

Burner

SP1/SS1

Orifice Bar

GAS LEAK TEST INSTRUCTIONS

Note: The gas leak test must be performed in an area that has adequate lighting

in order to see if bubbles are developing. DO NOT use a flashlight

to check for bubbbles.

1. Create a mixture of 50% water and 50% liquid dishwashing soap.

2. Turn the gas cylinder valve to the OFF position (clockwise).

Then turn regulator valve to OFF position (clockwise).

3. To turn ON the fuel supply, turn the cylinder valve

knob one turn counter-clockwise. Gas will flow through

and stop at the closed regulator valve.

4. Using a clean brush, apply the soap water mixture to the following:

Cylinder Valve to Cylinder

Connection Nut to Cylinder Valve

Back side of Connection Nut to Brass Nipple

Brass Valve next to Regulator

Regulator connection to Gas Supply Hose

LP Cylinder Welds

Full length of Gas Supply Hose

Gas Supply Hose connection to Burner

5. Check each place A - F for growing bubbles which indicates a leak.

6. Next, turn ON regulator valve (counter-clockwise) to permit gas to pass

through the hose. Apply soap water mixture to full length of gas supply hose

and connection to burner assembly. Check each place for growing bubbles,

G & H, which indicates a leak.

7. Turn OFF gas supply valve (clockwise) on LP Gas Cylinder.

8. Turn regulator valve to OFF position (clockwise).

9. Tighten any leaking connections.

10. Repeat soap water mixture test until no leaks are detected.

DO NOT use cooker if gas leaks cannot be stopped.

11. After you are certain there are no leaks, turn tank valve

and regulator valve to OFF position. Wait 5 minutes for

any gas fumes to evacuate before lighting the burner.

WARNING

WHEN TO PERFORM A LEAK TEST

• After assembling your cooker and before lighting for the first time, even if purchased fully assembled.

• Every time the LP gas cylinder is refilled or if any of the gas components are replaced.

• Any time your cooker has been moved.

• At least once per year or if your cooker has not been used for more than 60 days.

If growing soap bubbles persist throughout any portion

of the Gas Leak Test, terminate use immediately.

WARNING