Instructions / Assembly
14
O
N
-
C
O
U
N
T
E
R
-
C
L
O
C
K
W
I
S
E
O
N
-
C
O
U
N
T
E
R
-
C
L
O
C
K
W
I
S
E
O
N
-
C
O
U
N
T
E
R
-
C
L
O
C
K
W
I
S
E
S-L-O-W-L-Y
Turn Regulator Valve ON
LIGHT
BURNER
HERE!
Place lit Match over Burner
3
LIGHTING
ADJUST Air Control Shutter
for Blue Flame
4
ADJUST Regulator Valve
for Flame Height
5
NOTE: The brass valve on
regulator hose assembly
controls flame intensity
only. It is not an
ON/OFF valve. Practice
rotating the regulator
valve to become familiar
with flame adjustment.
Position hand
below burner
DO NOT light burner
at air intake
After lighting Burner, OPEN
LP Cylinder Valve FULLY
6
BURNER FLAME CHECK
Model #SP10/SS10/SQ84/SS84 Cooker
When lighting for the first time, you will smell paint burning at the top of the cooker
for a few minutes... This is normal.
Adjust flame height using regulator valve. Rotate air control shutter to achieve
mostly blue flame. The air control shutter mounted on the front of burner helps to control
the amount of air that mixes with the LP gas. A blue flame with little or no yellow flame
indicates a proper air/gas mixture and provides the best heat. Adjust the air control shutter
until the desired flame is achieved.
NOTE: Make sure the brass fitting on hose is screwed into the burner/air shutter and tightened securely. Do not over-tighten
as the air shutter needs to move freely in order to adjust air intake. Check the attachment for proper connection everytime
propane tank is connected to cooker.
HINT: Before lighting, turn air control shutter on the burner to an almost closed position. This increases the gas portion of the air/gas
mixture and makes the burner easier to light. After lighting, turn air control shutter to an open position to achieve a better flame.
If burner flame does NOT ignite immediately, or is accidentally extinguished, turn LP Gas Cylinder Valve clockwise to OFF.
Then turn regulator valve clockwise to OFF position. Wait 5 minutes for gas to evacuate before re-lighting, then repeat steps
1-6 to re-light. Always use caution when re-lighting as cooker frame and cooking vessel will be hot.
If the burner does not light within the first few attempts, there is a problem with the gas supply. Turn off the gas at the cylinder
and regulator. DO NOT attempt to operate the cooker until the problem is found and corrected.
Refer to Troubleshooting on Pages 24 - 25.
BURNER
FLAME
BLUE
ORANGE
CORRECT INCORRECT
HOW TO REIGNITE
Model #SP10/SS10/SQ84/SS84 Cooker
Follow steps 1 - 6 on previous page, to reignite burner. Use caution when re-lighting the burner, as hot oil from cooking vessel
may have splattered and run down the sides of the unit creating a slick surface. Use caution not to bump the cooker or cooking
vessel when re-lighting the burner.
COUNTER-CLOCKWISE
COUNTER-CLOCKWISE
COUNTER-CLOCKWISE