Instructions / Assembly
15
O
F
F
-
C
L
O
C
K
W
I
S
E
O
F
F
-
C
L
O
C
K
W
I
S
E
Turn COUNTER-CLOCKWISE
to Disconnect
TURNING OFF COOKER AND DISCONNECTING HOSE
Model #SP10/SS10/SQ84/SS84 Cooker
NOTE: Turn off LP gas cylinder valve first to prevent gas from being left in the regulator hose system under pressure.
1. Turn OFF the LP gas cylinder valve clockwise until it stops.
2. Turn regulator valve to the OFF position, clockwise until it stops.
3. To disconnect Regulator Hose Assembly, turn the large coupling nut counter-clockwise by hand.
Turn OFF
LP Cylinder.
Close Valve Fully
1
3
WARNING
The LP gas cylinder valve must always be in the OFF or closed position when the cooker is not in use.
LIGHTING INSTRUCTIONS - Model #SP1/SS1 JET COOKERS
Follow these instructions exactly. Read and follow all warnings and instructions in this manual before using your cooker.
1. Make sure regulator valve and cylinder valve are in the OFF position.
2. Look into the jet tube to be certain that orifice hole in brass cap is facing straight up. If needed, use a wrench to turn the
brass cap so that the orifice hole is facing straight up.
3. Make certain that Flame Spreader is in open position.
4. Turn ON the fuel supply by S-L-O-W-L-Y rotating the cylinder valve counter-clockwise one full turn.
HINT: Turning the cylinder valve quickly causes a sudden rush of gas that sometimes activates the Gas Flow Limiting Device.
To prevent this, always rotate cylinder valve S-L-O-W-L-Y.
5. Place fire place match or long lighter over the jet tube, then S-L-O-W-L-Y turn regulator valve clockwise until you hear gas
HISSING to the burner. Then light the cooker, keeping hands and face away from the top of the jet tube. In direct sunlight,
flame may appear clear.
6. Adjust the regulator valve for desired flame height.
7. After lighting, rotate cylinder valve to full open.
WARNING
DO NOT stand with head, body or arms over the cooker when lighting. Loose clothing and hair can catch fire.
BEFORE LIGHTING
O
F
F
-
C
L
O
C
K
W
I
S
E
O
F
F
-
C
L
O
C
K
W
I
S
E
Make sure LP Cylinder is OFF
1
Make sure Regulator Valve is OFF
2 & 3
Make sure Jet Tube is clean,
orifice hole facing straight up
and flame spreader is open
Flame Spreader
in OPEN Position
Jet Tube
Orifice
Hole
CLOCKWISE
Turn OFF Regulator.
Close Valve Fully
2
CLOCKWISE
Disconnect
Regulator
COUNTER-CLOCKWISE
CLOCKWISE
CLOCKWISE