Owner`s manual

A.3 PS-4C AND PS-4E: SERIAL CABLING
USING BAYTECH ADAPTERS OR TRAN-X
You may use an RJ-11 (4-wire) or RJ-45 (8-wire) cable when connecting
the PS-4C or PS-4E to Tran-x. The RJ-45 connectors on either device
will accept an RJ-11 plug. An RJ-11 plug will use the middle four pins
(i.e., pins 3 through 6) of the RJ-45 connector. These pins are labeled 1
to 4 in
Figure 16
on the following page (4-wire Cabling). Please see
Appendix A.3.1
if using 8-wire cabling or
Appendix A.3.2
if using 4-wire
cabling.
NOTE:
If you are connecting a Tran-x SP-01 or SP-02 high speed
converter and you wish to supply external power to the Tran-x, you must
use an 8-wire cable. Otherwise, you may use a 4-wire cable and an
external power supply on the Tran-x.
IMPORTANT:
If you will be connecting an EIA-232 serial printer, plotter,
or modem, you must use 8-wire cabling.
A.3.1 8-WIRE CABLING
Please use the cable diagram shown in
Figure 15
below when using 8-
wire cabling to connect the Print Server Plus to a BayTech printer adapter
or Tran-x converter.
A.3.2 4-WIRE CABLING
1
2
3
4
5
6
7
8 8
7
6
5
4
3
2
PIN
RJ-45RJ-45
PIN
1
Figure 15
: Crossed RJ-45 Cable
BayTech Part No. RJ08X010 (10 feet)