Owner`s manual

6a. Set up the local host workstation(s) as follows: Run
pcANYWHERE/LAN, select "Host Operations", select
"Active Configuration" (i.e., Dial-in, Int14), select
"Begin Host Operations", select "Exit, Allow Incoming
Calls", or "Wait for Connection".
NOTE:
It is suggested that the host workstation be
logged out of the network while awaiting a call for
security reasons. A remote user would typically log-in
when a virtual connection is established with the local
host workstation.
6b. A remote user initiates the dial-in connection by first
loading pcANYWHERE/LAN on the remote
workstation. Perform a normal modem dial command
to dial to the network modem. If using leased phone
lines, the modems should connect once both are
powered on.
6c. Once a modem connection is made, an access code
will appear if enabled in PSQMGR. If so, type the
required access code (see Step 2f). Once the correct
access code has been entered or if
Access Code
is
disabled, the
Prompt String
will be sent to the remote
workstation (default is ^M^JEnter Workstation ID (Ctrl-
C to Hangup):). Type the appropriate workstation ID.
This will be the same workstation ID as that
described in Step 4. The remote user has up to 60
seconds to enter the workstation ID once the prompt
string appears. The local host workstation will then
automatically go into pcANYWHERE/LAN. Both
workstations will remain connected until the
connection is terminated.