Owner`s manual

102
SYMPTOM: SOME SORT OF PORT SELECT CODE PRINTS
ON DOCUMENT
CAUSE: Port Select Code sent does not match Port
Select Code configured in Model 24.
SOLUTION: Match the Port Select Code sent exactly
with that configured in Model 24.
PROBLEM: CANNOT SELECT PRINTER DURING PRINT JOB
CAUSE: You are using Port Select Mode B (port
selection at beginning of sending only).
SOLUTION: Switch to Port Select Mode A in
configuration (port selection anytime while
sending).
PROBLEM: HOT KEY SOFTWARE HANGS UP PC WHEN
EXECUTED.
CAUSE: LPTX not rerouted for serial communication.
SOLUTION: Reroute LPTX using this command:
MODE LPTX:=COMX (X = 1, 2 or 3)
CAUSE: Floating condition on DSR or CTS lines.
SOLUTION: Using TERM program, check
hand-shaking line. Power down Model 24. If DSR,
DCD and CTS lines do not go low, cable wiring
needs to be checked.