Owner`s manual

58
For example, if you entered "100" for 100 seconds, the Model 24 will
respond with:
Input Inactivity Timeout is 100 second(s)
Enter New Value (0 to 200), or ENTER for no change :
If no other change is required, strike <ENTER>. The Model 24 will
respond with the reconfigured status and the prompt. You may now set
the timeout for another computer port, or exit by striking <ENTER>.
The Model 24 will save the new input inactivity timeout(s) permanently
in non-volatile memory and return to the main configuration menu (see
Section 7.1).
$( +
OPTION ACCESSIBILITY: Through Port 1 with full menus, or through
any serial computer port with abbreviated menus.
By responding to the Enter Request: message at the end of the main
configuration menu (Section 7.1) with "8" (Enable/Disable Form Feed
Mode), you may enable form feed and select when form feed occurs, or
disable form feed. The Model 24 will respond with:
•••••••••••••••••••••••••••••••••••••••••••••
•
Port
•
Computer
•
Form Feed
•
I.D.
•
• •
Logical Name
•
Begin
•
End
•
Page
•
•••••••••••••••••••••••••••••••••••••••••••••
•
1
•
Device A
•
Off
•
Off
•
Off
•
•
3
•
Device C
•
Off
•
Off
•
Off
•
•••••••••••••••••••••••••••••••••••••••••••••
Enter Computer Port Number (ENTER = Exit) : 1
Enter the number of the port for which you wish to set the form feed
mode and then strike <ENTER>. For example, if you entered "1" and
<ENTER>, the Model 24 will respond with:
Form Feed at the Beginning of Printing is ( Off )
Enter 1 for ON, 2 for OFF , ENTER for no change :