Owner`s manual

Connect to the Internet

Now that you have the thermostat in and working, it is time to connect it to the Internet to

enable it's advanced capabilities.

A) Connect the Control Module to the Internet. Plug one end of an Ethernet cable into the

LAN port on the bottom of the Control Module and the other end into a port on a router

or switch on your home network.

B) If direct wiring is not convenient, use power line Ethernet adapters. Plug one adapter

into a power plug near the control module, and the other adapter near your home

router. Then just plug the Ethernet cables into the adapters and the ports.

C) The BAYweb Thermostat does not require any configuration or programming of your

networking equipment. You do not need to change security settings. Just plug it in and

you are all set to go.

D) In less than a minute the “Uplink” light should illuminate on the control module. If it

does, your thermostat is on line and ready to go. Go to the Operation section below. If

you do not see “Uplink” light up within a couple of minutes, refer to the Troubleshooting

section of this manual.