If you have any questions contact the SAS Technical Support Department at: Phone - (800) THE TUBE Fax - (225) 272-9844 In Canada: (604) 988 2966 Email - tech@bazooka.com Website - www.bazooka.com 15049 Florida Blvd., Baton Rouge, LA.
CONTENTS Dear Friend, Thank you for selecting the Bazooka® Mobile Audio CS8A5 for your car stereo system. The Bazooka CS8A5 represents our continued commitment to efficiency and design. An innovative manufacturing process we developed for the Bazooka provides consumers with state-of-the-art speaker system design.
BEFORE YOU BEGIN--SAFETY PRECAUTIONS FEATURES AND SPECIFICATIONS Be sure to fuse the power wire within 12 of the cars battery. This will protect the cars battery in case of a short circuit between the CS8A5 and the battery. Fits in all vehicles To ensure maximum power transfer and secure safe connections, it is recommended to use high-grade crimp connectors or solder. Do not run any wires underneath vehicle. Exposed wires have a chance of being cut or damaged.
INSTALLATION MOUNTING THE CS8A5 Front Right Locate an area in the rear of the vehicle where you would like to place the CS8A5.. The location you have selected must meet the following requirements in order for the CS8A5 to be properly installed in the vehicle: Rear Right Subwoofer 1) The woofer (grill end) should be facing into a corner. 2) Ideally, there should be 2 to 4 inches between the woofer and the corner it is pointing into.
MOUNTING THE CS8A5 Figure 1 Figure 4 Bottom Top 1. With the topside of the buckle facing up (see figure 1), lace the strap through the mounting base as illustrated in figure2. 3. Place each mounting base under the CS8A5 so that the apex at the bottom of the tube sits inside the mounting base as in figure 4. Figure 2 ,, 3 Figure 3 Figure 5 ,, 3 4. Move the bases so that they are spaced approximately 3 from each end of the enclosure as illustrated in figure 5. 5.
See Model Size For Length WIRING DIAGRAM Figure 6 7. Remove any slack in the strap by feeding it out of the mounting base on the loose end of the strap opposite the buckle. 8. Place the CS8A5 on the mounting bases and fasten the buckles as illustrated in figure 7. The strap should loop through the buckle and be tightened securely by holding the strap in place with one hand and pulling the loose end away from the buckle, but against the cabinet.
HARNESS CONNECTOR DETAIL POWER WIRE 8 pin input connector 1 The 12 gauge red wire on the 2-pin connector is the 12 Volt positive power wire. It must be fused and connected directly to the positive terminal of the battery to provide a power source with a low voltage drop and low noise. Do not make the power connection at the fuse block or any point other than the battery. Improper power sources can reduce output and cause distortion.
REMOTE TURN ON OPTIONS SETTING THE LEVEL The BLUE with WHITE wire on the CS8A5s 10-pin connector is the remote turn on wire. You have two options in connecting the remote turn on wire. Select the option best suited for your application. To set the level of the CS8A5, start with the F/R GAIN and the SUB GAIN control all the way down. (Fully counter-clockwise). Play a music track with high dynamic content and turn up the source unit to at least 3/4 volume.