Specifications

1. With the topside of the buckle facing up (see figure 1), lace the
strap through the mounting base as illustrated in figure2.
MOUNTING THE CS8A5
2. After the strap is completely laced through the mounting base,
make a loop with the strap, where it runs across the middle of
the base as illustrated in figure 3. This loop is necessary to access
the two mounting holes in the base.
Bottom
Top
Figure 1
Figure 2
Figure 3
7
Figure 5
3
,,
3
,,
Figure 4
3. Place each mounting base under the CS8A5 so that the apex
at the bottom of the tube sits inside the mounting base as in
figure 4.
4. Move the bases so that they are spaced approximately 3 from
each end of the enclosure as illustrated in figure 5.
5. Remove the CS8A5 without moving the mounting bases and
set it aside.
6. Screw each mounting base securely in place with screws
provided as illustrated in figure 3.
8