Specifications

SAFETY PRECAUTIONS
Fuse amplifiers power wire at the battery.
Be sure to fuse the power wire within 6” of the vehicles battery. This will protect the vehicle and CSS-3I in
case of a short circuit between the CSS-3I and battery.
Use high grade wire connectors.
To ensure maximum power transfer and secure safe connections, it is recommended to use high grade
barrier spades (for connection at amplifier if applicable) and terminal rings (for connection at battery).
Do not run any wires underneath vehicle.
Exposed wires have a chance of being cut or damaged. It is best to run all wires through the vehicle under
the carpet and/or side panels. This lends to a cleaner installation and less risk of damage.
Use caution when mounting the CSS-3I.
Remember there are many electrical wires, gas lines, vacuum lines, brake lines as well as a gas tank in the
automobile. Make sure you know where they are when mounting the amplifier to avoid puncturing lines,
shorting wires or drilling holes in the gas tank.
Run signal wires away from electrical wires.
To avoid possibility of induced noise from the vehicles electrical system (i.e. popping noises or engine noise),
run wires away from the vehicles electrical wiring.
Make all ground wires as short as possible and at the same point.
In order to reduce the chance of ground loops (i.e. engine noise), make the grounding wire as short as
possible to reduce the wire's resistance. Also, when using multiple components, make sure all units are
grounded at the same point.
Avoid sharp edges when running the wires.
To avoid the possibility of power, signal or speaker shorts, be careful not to allow the CSS-3I wires to come in
contact with sharp edges. Use a grommet to protect the wire when running through the fire wall .
3