Owners manual

8
ASSEMBLY
IMPORTANT ASSEMBLY INFORMATION
• Assembly requires a 8/16” socket and ratchet (or
a 8/16” open-end wrench) and a Philips screw-
driver (not included).
• Assembly requires two or three adults. Keep
children away from the trampoline enclosure until
it is fully assembled.
• Use gloves to protect your hands from pinch
points during assembly.
• Make sure that the trampoline is properly assem-
bled, with the frame pad properly attached, before
you assemble the trampoline enclosure.
• The assembly steps refer to parts by their
descriptions and key numbers (see the PART
LIST on page 14).
• See the EXPLODED DRAWING AND PART LIST
on page 14 and make sure that all listed parts are
included. If a part is missing, see ORDERING
REPLACEMENT PARTS at the bottom of page
14.
TRAMPOLINE PLACEMENT
1. Place the trampoline and enclosure on a level
surface before use.
2. Adequate overhead clearance is essential. A
minimum of 7.3 m (24 ft.) from ground level is
recommended. Provide clearance for wires,
tree limbs, and other possible hazards. Lateral
clearance is also essential. Place the trampo-
line and enclosure away from walls, struc-
tures, fences, and other play areas. Maintain a
clear space on all sides of the trampoline and
enclosure.
3. Use the trampoline and enclosure in a well-
lighted area.Artificial illumination may be
required for indoor or shady areas.
4. Secure the trampoline and enclosure against
unauthorized and unsupervised use.
5. Remove any obstructions from beneath the
trampoline and enclosure.
6. The trampoline enclosure is only to be used
as an enclosure for a round trampoline.
1. Make sure that you understand the informa-
tion in the box at the top of this page before
you begin assembling the trampoline enclo-
sure.
Loosen the straps (not shown) on the underside of
the frame pad (for clarity, the frame pad is not
shown in steps 1 and 3). Do not remove the
frame pad from the trampoline.
See the insert drawing.
1
Slide a U-bolt bracket (2) onto the U-bolts(3)
, then thread locknuts (1) two turns onto
the U-bolts.
Repeat this step on the other seven leg
sections (not shown).
1
1
1
2
2
2
3
13
13
Socket
Left Leg
Leg Section
U-bolts