User`s manual

Frame

V-ring

Spring (7):

During the installations of spring, wear

gloves and protective eye wear.

Hook the V-ring

3. Lay the Bed (5) on the ground inside of the

assembled frame. Make sure that the two warn-

ing decals (not shown) are on top of the Bed.

Note: There are V-rings around the edge of the

Bed (5) and holes around the top of the frame.

During this step, you will attach the Bed to the

frame using the included Springs (7) for holes

on top of frame and Springs(7) for holes

on bottom of frame (see the inset drawing).

Hook a Spring

into one of the V-rings with yellow

webbing location on the Bed(5) and into one of the

holes in the frame. Attach a second Spring with

yellow webbing location directly across the Bed

from the first Spring. Attach two more Springs with

location halfway between the first two Springs,

so four Springs are attached as shown.

Attach four more Springs(not shown) halfway betw-

een the first four Springs. Continue attaching

Springs halfway between the previously attached

Springs, until all the Springs are attached.

Hook a spring to the Bed(5) and using the spring

pulling tool(17), pull the spring from the Bed to the

hole slot in the trampoline frame with even spring

tension.

To attach each Spring, you will first hook one end

of the Spring into a V-ring with yellow webbing

location (see the inset drawing).