Operation Manual

SECTION 1B : INSTALLATION - HEART RATE

The heart rate sensors are integrated in the soft elastic belt.

For a correct heart rate measurement, the belt must be

positioned slightly below your chest, directly on your skin.

1. Make the two contact areas moist before you start your

exercise.

2. The chest belt needs to be snug to stay in place. Slide the

buckles to adjust the length of the belt for a snug but

comfortable fit.

3. Press the ANT+ transmitter to the elastic belt on the two

push-button connectors.

Maintenance

- Remove the transmitter from the elastic belt after every

use and dry the push-buttons connectors on the transmitter.

Rinse the soft elastic belt under running water after every

use.

- Wash the elastic belt regularly in a washing machine at 30ºC.

Use a washing pouch. Do not spin-dry, iron, dry clean or

bleach the elastic belt. Do not use detergent with bleach or

fabric softener.

- Never put the transmitter in the washing machine!

INSTALLING THE HEART RATE SENSOR

The sensor batteries are pre-installed. When needed, check below illustrations for correct

replacement.

1. Open the battery cover by turning the cover counter clockwise.

2. Insert the battery (CR 2032) with the negative side (-) facing up for 3 seconds. This will

reset the sensor.

3. Insert the battery (CR 2032) with the positive side (+) facing up. Close the battery cover

by turning it clockwise.

Batteries should be disposed of in compliance with local regulations.

» BATTERY REPLACEMENT FOR THE HEART RATE SENSOR