Operation Manual

SECTION 1C : INSTALLATION - CADENCE

1. Install the cadence magnet on the non drive train side of the crank.

2. Install the cadence sensor on the chainstay.

3. Position the cadence sensor on the chainstay to achieve the correct alignment with the

cadence magnet. If needed, move the cadence magnet. The distance between the magnet

and the sensor point should be maximum 3mm. When you have achieved the correct align-

ment, pass two zip-ties through the sensor and around the chainstay.

4. Cut off the excess length of the zip-ties.

INSTALLING THE CADENCE MAGNET AND CADENCE SENSOR

The sensor batteries are pre-installed. When needed, check below illustrations for correct

replacement.

1. Open the battery cover by turning the cover counter clockwise.

2. Insert the battery (CR 2032) with the negative side (-) facing up for 3 seconds. The will

reset the sensor.

3. Insert the battery (CR 2032) with the positive side (+) facing up. Close the battery cover

by turning it clockwise.

Batteries should be disposed of in compliance with local regulations.

» BATTERY REPLACEMENT FOR THE CADENCE SENSOR