Inst. Manual_N2WW(UE2-A) 5/30/05 3:08 PM INSTRUCTION MANUAL Page 1 LCD-27XA2 LCD-32XA2 LCD Colour Television P Please read this Instruction Manual before using your television. We wish you many hours of pleasure from your new television.
Inst. Manual_N2WW(UE2-A) 5/30/05 3:08 PM Page 2 Warnings and Cautions Do not drop or push objects into the television cabinet slots or openings. Never spill any kind of liquid on the television receiver. To prevent fire or electrical shock hazard, do not expose the television receiver to rain or moisture. Minimum Distances 5 cm 10 cm 10 cm High voltages are used in the operation of this television receiver. Do not remove the cabinet back from your set. Refer servicing to qualified service personnel.
Inst. Manual_N2WW(UE2-A) 5/30/05 3:08 PM Page 3 Installation Step 1 : Connecting the Aerial and Power Supply • Connect your aerial cable plug to the rear of the TV set. For further information please consult your local dealer. • Connect the AC power plug to the wall socket (AC100-264 Volts, 50Hz/60Hz). Note: The form of the AC code and AC plug are different with each country. ANT.
Inst. Manual_N2WW(UE2-A) 5/30/05 3:08 PM Page 4 Installation Step 2 : Battery Installation of the Remote Control Transmitter Use 2 “AAA” 1.5 volt batteries. Be sure batteries are installed correctly. Note: Do not mix old batteries with new ones or mix different type of batteries together. Step 3 : Switching on/Plug & Play Let’s start ! This TV set provides a self-automatic tuning system function called “Plug & Play”.
Inst. Manual_N2WW(UE2-A) 5/30/05 3:08 PM Page 5 Control Panel Each button listed this section has the same function as it’s corresponding button on the Remote Control P Stand-by and Power Indicator Volume Programme Up/Down Remote Control Detector Power ON/OFF button Viewing Angle Adjustment Swivel stand is rotated 360˚ right and left. Caution P Do not position hand under the screen frame while rotating the TV.
Inst. Manual_N2WW(UE2-A) 5/30/05 3:08 PM Page 6 Remote Control Transmitter Recall/Colour System Wide Power ON/OFF Digital Shot Sound Mute TV/AV Selector To select half mute, full mute or restore the sound. Press repeatedly to switch to TV, AV1, AV2, AV3, AV4 or AV5 mode. DVD button TIMER To call up the Timer menu directly. Numeric buttons Programme Up/Down To select the next or previous programme position. Digit Alternate These buttons are not used.
Inst. Manual_N2WW(UE2-A) 5/30/05 3:08 PM Page 7 General Operation Power ON/OFF(Stand by) Press the Power ON/OFF button to turn on or off (Stand-by) the TV set. Lighting of the Stand-by and Power Indicator shows that there is a power supply. For shutting off a power supply completely, disconnect the power cord from the power outlet. You can turn on the TV in the standby mode by pressing the following buttons in addition to the Power ON/OFF button.
Inst. Manual_N2WW(UE2-A) 5/30/05 3:08 PM Page 8 General Operation A2 Ster eo, NICAM Ster eo and Bilingual Br oadcast Receiving Pr ogramme Infor mation Call To display the on screen indication, press the Recall/Colour System button. ■A2 Stereo and NICAM Stereo sound reception When receiving NICAM stereo broadcast, NICAM will be displayed on the screen. For A2 (German) stereo broadcasts, Stereo will be displayed.
Inst. Manual_N2WW(UE2-A) 5/30/05 3:08 PM Page 9 General Operation Scr een Mode Selection Today there are various transmission formats with different size ratios, e.g. 4:3, 14:9, 16:9 and video format such as letterbox. 4:3 picture sometimes have a black band at the top and bottom of the screen. You can select a screen mode to optimise the picture display.
Inst. Manual_N2WW(UE2-A) 5/30/05 3:08 PM Page 10 General Operation Zoom 14:9 4:3 14:9 16:9 Letterbox Video Zooms in slightly cropping the top and bottom. Zooms in slightly cropping the top and bottom. The black bars top and bottom are smaller and the picture height is compressed slightly. 4:3 14:9 16:9 Letterbox Video TITLES ON SCREEN TITLES ON SCREEN TITLES ON SCREEN TITLES ON SCREEN As zoom (14:9), but bottom is compressed even more to allow subtitles to be seen.
Inst. Manual_N2WW(UE2-A) 5/30/05 3:08 PM Page 11 General Operation Title-in 16:9 4:3 14:9 16:9 TITLES ON SCREEN TITLES ON SCREEN TITLES ON SCREEN As Zoom (16:9), but bottom is compressed even more to allow subtitles to be seen. As Zoom (16:9), but bottom is compressed even more to allow subtitles to be seen. As Zoom (16:9), but bottom is compressed even more to allow subtitles to be seen.
Inst. Manual_N2WW(UE2-A) 5/30/05 3:08 PM Page 12 General Operation 1 2 Digital Shot Select a picture that you want to display 1 Use Digital Shot function to capture and save the up to 12 pictures and replay them in a list mode, full screen mode and automatic album mode. with the cursor button. / or / 3 Press the OK button to display. 1 How to capture the pictures 1 Press the Digital Shot button to capture a scene that you want to store. (The screen is not frozen at this time.
Inst. Manual_N2WW(UE2-A) 5/30/05 3:08 PM Page 13 General Operation 1 Auto Album Deletion of pictures Use this function to display each picture continuously. 1 Press the CS button to display the screen of List mode. 1 Press the CS button to display the screen of List mode.
Inst. Manual_N2WW(UE2-A) 5/30/05 3:08 PM Page 14 Menu Operation The on-screen menu provides the viewer with easy access to adjustments and settings. Follow the on-screen instruction at the bottom of the screen.
Inst. Manual_N2WW(UE2-A) 5/30/05 3:08 PM Page 15 Menu Operation 4 Press Sound Volume Bass Treble Balance BBE Auto Volume or to set OFF timer. The time changes in 30 minutes steps. The maximum time is 2 hours. 23 5 20 0 5 Press or to make row of OFF timer complete yellow. ON OFF 6 Press the OK button to store the setting. 3 Press or Press the MENU button to exit, or press to set alarm timer. to adjust. • Balance : Left and Right speaker volume balance adjustment.
Inst. Manual_N2WW(UE2-A) 5/30/05 3:08 PM Page 16 Menu Operation Setting Menu Preset Menu This setting menu gives you several options to adjust. 1 Press the MENU then or button to select “Setting” menu. 2 Press to select a content. or OFF Min A English Video to set each option. • Child Lock (ON, OFF): You can prevent that a small child operates television with the front control button of the TV set. When the power plug is pulled out, this function is cancelled.
Inst. Manual_N2WW(UE2-A) 5/30/05 3:08 PM Page 17 Menu Operation 5 You can either... Semi-auto Tuning This is used to preset a channel in any programme position. 1 Select “Prog. Preset” with in the Preset menu. P Preset > > Auto Tuning Prog. Preset Swap Fine Tuning 2 Press --- <> to enter the Semi-auto Tuning mode. P Semi Frequency Position System Sound 271.65 MHz 007 Auto BG 3 Select “Position” with .
Inst. Manual_N2WW(UE2-A) 5/30/05 3:08 PM Page 18 Menu Operation Setting of the Skip Channels Channel Swapping If there are positions you do not use, by setting skip channel function, it is possible to jump over any position when you are selecting a channel using the Programme Up/ Down button. Use this feature to swap the channels between two stored programme positions. This feature is particularly useful after automatic tuning. 1 Select “Position” in the Semi menu.
Inst. Manual_N2WW(UE2-A) 5/30/05 3:08 PM Page 19 Setting of the Hotel Mode The Hotel Mode is a feature that might be needed by a hotel management to confine the TV that put in the hotel room, so it will not disturb other rooms. Setting Procedure 1 Set the desired maximum sound volume by pressing the Volume + or - button. 2 Press and hold the Recall/Colour System button on the remote control and press the Programme Up button on the TV set.
Inst. Manual_N2WW(UE2-A) 5/30/05 3:08 PM Page 20 Teletext Operation Cancel To view the TV picture in the teletext mode while waiting for sub page to change or page to update. Press again to return to teletext mode. (Note: The page number will appear when the page is updated.) Reveal switch To reveal hidden items on the text page e.g. a hidden answer to a quiz question. Direct access to a page To select a page number directly using the (0-9) NUMERIC buttons.
Inst. Manual_N2WW(UE2-A) 5/30/05 3:08 PM Page 21 VCR and DVD Use This remote control transmitter has been designed to be used in conjunction with selected SANYO VCR’s and DVD players. Some SANYO VCR’s and DVD players may have their own functions, so please refer to the individual instruction booklet when using this remote control to ensure compatibility. Some of the buttons are used for both the VCR and DVD player. The symbols indicated with blue are for the buttons to control the DVD player.
Inst. Manual_N2WW(UE2-A) 5/30/05 3:08 PM Page 22 AV Terminals Side Terminal AV4 VIDEO L AUDIO Audio Video Input Jacks (AV4) R Rear Terminal Headphone Jack (Mini Stereo Jack) For personal listening, a headphone can be connected to the headphone jack.
Inst. Manual_N2WW(UE2-A) 5/30/05 3:08 PM Page 23 Connecting Other Equipment You can connect a VCR, S-VHS VCR, Satellite Tuner, PAY TV Decoder, DVD or Camcoder to this TV via the AV terminals and the SCART terminal. ■ Depending on the type of video tape or connected AV equipment being used, it may be necessary to select colour system. In this case, press the Recall/Colour System button and select a suitable colour system. Colour system setting for AV position is automatically stored in the memory.
Inst. Manual_N2WW(UE2-A) 5/30/05 3:08 PM Page 24 Connecting Other Equipment Connecting to the Rear AV5 Input Jacks DVD Player Connection If your DVD player has the component video output jacks, connect the TV to these jacks instead of the video input or S-VIDEO input jacks. You can enjoy high quality picture playback.
Inst. Manual_N2WW(UE2-A) 5/30/05 3:08 PM Page 25 Connecting Other Equipment Connecting to the Side AV4 Input Jacks It is convenient to use the AV4 input jack on the side panel for equipment that is often connected and disconnected. Camcorder AV4 PLAYBACK VIDEO L AUDIO R Video Game Headphone ■ Select “AV4” mode by pressing the TV/AV Selector for watching. Connecting a Stereo Amplifier to Audio Monitor Output Jacks Connect Audio Monitor Out terminals (R/L) to the Stereo Amplifier Input (R/L).
Inst. Manual_N2WW(UE2-A) 5/30/05 3:08 PM Page 26 Helpful Hints ■ Helpful hints ■ NO PICTURE, NO SOUND ● Check if TV is plugged in. ● Try a different channel, if OK, probably station trouble. ■ POOR PICTURE, SOUND OK ● Adjust BRIGHTNESS control. ● Adjust FINE TUNING control. ● Check aerial connections ■ NO COLOUR, PICTURE OK ● Adjust COLOUR control. ● Adjust FINE TUNING control. ● Is the programme in colour ? ■ WEAK PICTURE ● Check aerial connections on back of set. ● Check aerial for broken wires.
Inst. Manual_N2WW(UE2-A) 5/30/05 3:08 PM Page 27 Specifications Power Source AC100-264 Volts, 50Hz/60Hz Colour System PAL/SECAM/NTSC4.43/NTSC3.58/PAL-60Hz Sound System B/G, D/K, I, M/M Channel Coverage VHF: E2-E12, A2-A13,R1-R12,J1-J12,K1-K9 UHF: 21-69,A14-A69,J13-J62 CATV: S1-S41, X, Y, Z, Z+1, Z+2 Aerial Input Impedance 75 Ω LCD Panel (Model LCD-27XA2) Screen Size (Measured Diagonally): 27 inches Picture Resolution: WXGA 1280 (Horiz.) x 720 (Vert.) pixels Viewing Angles: Horiz. 176˚, Vert.
Inst. Manual_N2WW(UE2-A) 5/30/05 3:08 PM Page 28 Specifications Dimensions Model LCD-27XA2 (Unit : mm) 153 109 800 436 476 338 210 599 377 233 Model LCD-32XA2 (Unit : mm) 153 115 922 377 506 545 401 245 711 233 Specification subject to change without notice Part No. 1AA6P1P4901- - N2WW (UE2-A) SANYO ELECTRIC Co., Ltd.
