▲ BBE DI-10 USER MANUAL
Congratulations on the purchase of your BBE DI-10 direct box! The BBE DI-10 is an active direct box used for converting line out and speaker out signals to balanced and unbalanced signals. The user also has the ability to select between two frequency responses (flat, or speaker compensated). Using the outputs from the DI-10, the user can direct feed to a mixer, recorder, or sound reinforcement system. The features that make up the BBE DI-10 are: 1. Speaker thru and Speaker input jacks. 2.
FRONT PANEL CONTROLS 1 2 REAR PANEL CONNECTIONS 3 1. D.C. INLET: This jack is for connecting the 9 VDC power source. The 9 VDC power plug must be of the type where the positive voltage is on the outer ring. 2. FILTER SWITCH: This switch is used to operate the speaker simulating filter. When the filter is off, system frequency response is flat. When the filter is on, a 4th order filter network is activated and the system frequency response is 6dB down at 4kHz. 3.
SPECIFICATIONS FREQUENCY RESPONSE FILTER OFF . . . . . . . . . . . . . . . . . . .5Hz to 30kHz FILTER ON . . . . . . . . . . . . . . . . . . . .40Hz to 4kHz SIGNAL TO NOISE RATIO . . . . . . . . . . . .108dB (Filter Out) (USING A 9V BATTERY) TOTAL HARMONIC DISTORTION . . . . .0.02% (20hz - 20khz) INPUT CHARACTERISTICS INPUT IMPEDANCE . . . . . . . . . . . .50k OHMS (Line In) . . . . . . . . . . . . . . . . . . . . . . . . . . . . .470k OHMS (Speaker In) LINE INPUT LEVEL . . . . . . . . . . . . .
