User guide

2011-2014 Ford Mustang V6

Tuned Length Headers

Part # 1442, 14420

INS-197

Special Tools

Required:

•

No special tools

required

Install Time:

Approximately

1 Hour

Difficulty:

3 out of 5

Follow these instructions carefully to ensure correct fitment and operation.

STEP 1

STEP 2

STEP 3

• Disconnect the negative battery terminal, then

raise and support the vehicle using jack stands

or a car stand.

• Remove the heat shields on the exhaust

manifolds. Remove the 6 nuts securing each

exhaust manifold to the cylinder head. Remove

the Header and Gasket from the vehicle.

NOTE!!! These manifolds can be removed

from the top of the engine compartment.

• Unbolt the factory x-pipe from the exhaust

manifolds and let it hang down. This will aid in

tightening the passenger side BBK Header.

Removing this bolt will free the coolant line secured to

the engine and aid in space for tools to remove and

install the headers.

There are 3 nuts on the top and bottom of both driver

side and passenger side exhaust manifolds.

PAGE 1
2011-2014 Ford Mustang V6 Tuned Length Headers Part # 1442, 14420 Special Tools Required: • No special tools required Install Time: Approximately 1 Hour Difficulty: 3 out of 5 Follow these instructions carefully to ensure correct fitment and operation. STEP 1 • STEP 3 There are 3 nuts on the top and bottom of both driver side and passenger side exhaust manifolds. Disconnect the negative battery terminal, then raise and support the vehicle using jack stands or a car stand.
PAGE 2
011-2014 Ford Mustang V6 Tuned Length Headers Part # 1442, 14420 STEP 4 • • Install the supplied studs onto the BBK Header Collectors. STEP 5 For both the driver side and passenger side place the supplied BBK Gasket and header into place. Then Tighten. NOTE!!! The passenger side is a little more tricky. Make sure to leave all the nuts loose so the header has room to move. With the stock x-pipe hanging out of the way, the bottom rear nut needs to be tightened from behind the collector.