Owners manual

BBK Short H-Pipes/X-Pipes

For Full-Length Headers

INS-005

Special Tools

Required:

•

No special tools

required

Install Time:

Approximately

30 mins

Difficulty:

1 out of 5

Follow these instructions carefully to ensure correct fitment and operation.

STEP 1

STEP 4

STEP 2

STEP 3

• After installing your new BBK full-length

headers, you can now install the matching short

H-Pipe/X-Pipe by simply bolting it in place of the

old H-Pipe Assembly.*

• Using the supplied hardware, bolt up the BBK

H-Pipe/X-Pipe.

• NOTE!!! Be sure to add a small amount of

anti-seize to the top thread of each oxygen

sensor using the supplied anti-seize packet.

As you thread the oxygen sensor back into

the part the anti-seize will spread evenly

throughout the threads.

• Using the washers and nuts supplied with your

full lengths stud kit, mount the front H-Pipe/X-

Pipe flanges to the header collectors.

• Reconnect the factory air tube if installing

catalyst equipped pipes.

*It may be necessary to use some WD-40 to aid in removal of the stock midpipe. Due to the

metal to rubber slide mount these units can be sticky.