Owner manual

Passenger-Side
Step 14 Unbolt and remove starter from bell housing.
Step 15 Remove motor mount from block if needed.
Step 16 Remove stock exhaust manifold and gasket.
Step 17 Install BBK header and supplied gasket.
Step 18 Insert and finger tighten the supplied collector studs.
Step 19 Re-install motor mount and starter.
Step 20 Lower motor mounts onto their mounting studs
and tighten nuts.
Step 21 Re-install the steering shaft.
Step 22 Re-install H-pipe using supplied washers, lock
washers and nuts at collectors.
Step 23 Re-connect the oxygen sensors.
Step 24 Re-connect negative battery terminal.
After driving the car for a few hours it’s always a good idea to
check and re-tighten the header bolts.
Please visit us at www.BBKPERFORMANCE.com to view a fully photographed
installation of this and the many other BBK products. To maximize your vehicle’s
performance potential we recommend the following BBK PERFORMANCE products:
BBK HI-FLOW X-PIPE
BBK THROTTLE BODY
BBK COLD AIR INDUCTION SYSTEM
BBK PERFORMANCE UNDERDRIVE PULLEYS
INS-098
Remove top nuts.
Removing the oxygen sensor.
Separate H-pipe from tail pipe.
Remove starter.
Remove dipstick tube.
Disconnect steering shaft.