Owners manual

2005-2010 Mustang V6

Dual Exhaust Conversion

X-Pipe Kit

Part # 4011

INS-170

To complete this installation will be require the purchase of a Mustang GT Axle Back kit of your choice and (2)

Mustang GT Driver side brackets. The muffler brackets and bolts can be ordered through your local Ford

Dealer.

Follow these instructions carefully to ensure correct fitment and operation.

Special Tools

Required:

•

No special tools

required

Install Time:

Approximately

2 Hours 30 Min

Difficulty:

3 out of 5

STEP 1

STEP 3

• Disconnect the negative battery terminal. Lift the

vehicle up and support on sturdy jack stands or

place on a vehicle lift.

STEP 2

• Disconnect all (4) Oxygen Sensors. Loosen and

slide back the barrel style clamp at the end of

the stock mid pipe section. Remove the

hardware at the exhaust manifold collectors for

the mid pipe section.

• Carefully remove the complete mid pipe section.

Install the catted down pipes to the exhaust

manifolds, leave slightly loose for adjustment.

PAGE 1
2005-2010 Mustang V6 Dual Exhaust Conversion X-Pipe Kit Special Tools Required: • No special tools required Part # 4011 Install Time: Approximately 2 Hours 30 Min Difficulty: 3 out of 5 To complete this installation will be require the purchase of a Mustang GT Axle Back kit of your choice and (2) Mustang GT Driver side brackets. The muffler brackets and bolts can be ordered through your local Ford Dealer. Follow these instructions carefully to ensure correct fitment and operation.
PAGE 2
005-2010 Mustang V6 Dual Exhaust Conversion X-Pipe Kit Part # 4011 STEP 4 • Lift X-Pipe in place and slide ½” rod brackets into the stock rubber mounts at the transmission mount. Connect to the catted down pipes with the (2) Supplied couplers. Tighten the couplers a little bit to hold pipes but allow for adjustability. STEP 5 • • Connect the stock passenger side exhaust pipe to the BBK X-Pipe with the stock clamp.
PAGE 3
2005-2010 Mustang V6 Dual Exhaust Conversion X-Pipe Kit Part # 4011 STEP 8 • • Hang muffler that you purchased on hanger brackets. STEP 9 • Install the BBK over axle pipe and slip the one end into the muffler pipe. Install the pipe to connect the axle pipe to the X-Pipe. Use the supplied barrel style clamps to connect. STEP 10 With all pipes in position and connected, adjust positioning for best fit of system.