Installation guide

Domes 23 April 2002 I.James
Version 1.3 Page 25 of 29 E & OE
Accessing the dome menu
In order to access the domes Menu using the DS press the <* Command> button. A key
assistance box appears which says which keys are used to navigate the following dome menu,
press <Menu> to continue.
* Is displayed next to the time and date (on screen) to indicate that the keyboard is controlling the
dome menu.
To navigate around the domes menu use the DS keyboards joystick (á, â) to move the Cursor 
from Line to Line.
Press the <Zoom +> key to select a menu item.
Press the <Zoom -> key to cancel.
To exit out of the Domes menu Select EXIT in the menu and press <Zoom +> (Enter).
The domes menu will disappear from the screen but * will still be at the bottom of the screen.
Press and hold down the <* Command> button to switch dome menu control off
(* disappears).
Domes Menu
<Camera>
<Line Sync>
<Power Up Mode>
<Aux>
<Alarms, Zone Blank>
Exit
The  symbol is the cursor.
Direct Key Presses:
Pelco Key/Function Digital Sprite Keyboard press
Access Main Menu (Enter Dome Setup) Press <*Command> then Press <Menu>
Exit Dome Menu Select EXIT in menu, then press and hold
<* command>
Enter Setting / Open a submenu (Enter) <Zoom +>
Move the Cursor Joystick (á,â)
Select a parameter Joystick (á,â)
Focus near <focus near>
Focus far <focus far>
Zoom in <Zoom +>
Zoom out <Zoom ->
Auto Scan <auto-pan>, Cancelled by joystick (ß,á,â,à)
Patrol / Pattern <patrol>, Recalls the saved Programmed
Pattern. Cancelled by joystick (ß,á,â,à)
Iris Open Press <Zoom +> and <Zoom -> together, then
<Zoom +>. Press <Zoom +> and <Zoom ->
together to return to normal Zoom operation.
Iris Close Press <Zoom +> and <Zoom -> together, then
<Zoom ->. Press <Zoom +> and <Zoom ->
together to return to normal Zoom operation.
Close Relay Output 0 <wash> momentary close
Close Relay Output 1 <wipe> latching ON/OFF
Close Relay Output 2 <lamp> latching ON/OFF