Installation guide

TX1500 Manual V5.1 April 2014 Page 15 of 36 MATRIX PROGRAMMING/USER GUIDE
Enter Pin Number
* * * * * *
+ or - = Enter Key
Joystick to Navigate
Press Program to exit
Exit
CONFIGURATION USING THE TX1500 MENUS
NOTE only Keyboard 1 can access the TX1500 system menu and only monitor 1 can display the menu.
Out of the box the TX1500 is configured to control BBV coaxial telemetry on all cameras and all Keyboards can control
all the monitors and cameras.
The TX1500 menu system allows the unit to be configured to your customer’s site requirements.
To access the menu select monitor 1 by pressing ‘1’ ‘MON’ and use Keyboard 1. Press and hold the ‘PROGRAM’ key
for 2-3 seconds and the following screen will be displayed and the ‘PROGRAM’ led is lit. If the menu is not displayed
then check that the program key is enabled on the Keyboard. Refer to the guide on Page 31.
Press for 2 seconds
The menu is displayed Enter the six digit PIN using
and the PROGRAM led keys 0 – 9.
becomes red.
The default PIN is 999999
Use the joystick left and right if a digit is entered incorrectly.
The TX1500 Main Menu is displayed if the PIN is correct otherwise the TX1500 reverts to normal control.
To navigate through the menu, use the joystick and either the +/- keys to
toggle a value or the numeric keys 0-9 if a value is required.
To exit the menu press the PROGRAM key at any point.
Each menu item is described on the following pages
TX1500 - Main Menu
System Basics
Access Tables
Alarm Menus
Sequences
Camera Types
Set Passwords
System Parameters
Exit press + to select