Installation guide

TX1500 Manual V5.1 April 2014 Page 25 of 36 MATRIX PROGRAMMING/USER GUIDE
System Parameters 2
Bump Cameras off
Return to patrol off
Priority Keyboard off
Startup Actions
Monitors in sequence
None
Return
SYSTEM PARAMETERS 2
Used to program additional settings as follows:
Bump Cameras:
Selects the Keyboard(s) that will remove the current camera from other monitors when controlled manually. This is to
prevent, for example, public display store monitors from displaying cameras that are following a suspect.
Use +/- to cycle through options:-
Off, Kbd 1, Kbd 2, Kbd 1 + 2, Kbd 3, Kbd 4, Kbd 1 + 2 + 3, Kbd 1+2+3+4
Return to patrol:
If set to on, the current camera will start a preset patrol 1, if supported, when another camera is selected. This is useful
for a system that has several cameras that should run preset patrols all the time that they are not controlled manually.
Priority Keyboard:
A Keyboard can be set that can take control of cameras at any time and is not locked out by other Keyboards.
Startup Actions – Monitors:
This option allows selected monitors to resume sequence should the system power fail and restore. Use +/- to cycle
between the monitor choices.
None, 8, 78, 678, 5678, 45678, 345678, 2345678, or 12345678.