Installation guide

TX1500 Manual V5.1 April 2014 Page 30 of 36 MATRIX PROGRAMMING/USER GUIDE
STARTING A PRESET PATROL
Press either 1 or 2 followed by the PATROL key.
The PATROL key LED will be RED whilst the current camera is running a
preset patrol.
To stop the camera from patrolling, move the joystick. The PATROL key LED
will now be BLUE.
As with presets, patrols are only available on moving cameras that are equipped for presets. Certain dome cameras
offer enhanced patrol features that will be covered in the product addendum sheet for each specific dome type.
STARTING A MONITOR CAMERA SEQUENCE
Pressing the SEQ key will start a camera switching sequence on the current monitor. The SEQ key LED
illuminates RED to indicate if the current monitor is running a sequence.
Each monitor can sequence individually and simultaneously.
The monitor sequence is programmed by the installation company using the system configuration menu.
To stop the sequence either press the SEQ key again to toggle the LED BLUE or select another camera.
BLUE SQUARE / RELAY KEY
Use the BLUE SQUARE key to operate the TX1500 change over relay on the monitor out card. This
can be used for a variety of purposes (Exluding AL1 on card 1, this is a general relay). Your
installation company will inform you of the specific function for your site.
The relays on each alarm card can also be switched as follows:
2 BLUE SQUARE – relay 2 alarm card 1
3 BLUE SQUARE – relay 1 alarm card 2 4 BLUE SQUARE – relay 2 alarm card 2
5 BLUE SQUARE – relay 1 alarm card 3 6 BLUE SQUARE – relay 2 alarm card 3
7 BLUE SQUARE – relay 1 alarm card 4 8 BLUE SQUARE – relay 2 alarm card 4
9 BLUE SQUARE – relay 1 alarm card 5 10 BLUE SQUARE – relay 2 alarm card 5
11 BLUE SQUARE – relay 1 alarm card 6 12 BLUE SQUARE – relay 2 alarm card 6
ALARM KEY
If the system has been configured for KEY PRESS alarms by the installation company, following a site alarm
the ALARM key LED will be RED, the alarm monitor will display ‘alarm’ and the alarm Keyboard will beep.
The alarm is acknowledged by pressing the ALARM key. The alarm monitor/s will display the camera/s
programmed for this alarm.
S
E
Q
1 2 3
0
5 64
8 97
P
A
T
R
O
L
A
L
A
R
M