Installation guide

BBV_1-2-1 _Protocol_converter_manual_V41_November_2013 Page 13 / 40
Protocol specific information
360 VISION from BBV
Ensure that the dome at the end of a daisy chained RS485 run has the RS485 terminated and the
intermediate domes have the RS485 de-terminated.
The following functionality is provided:
Manual pan/tilt control with 16 speed steps from 1 to 127, (slowest to fastest)
Zoom with Manual Iris and Focus override.
Operating the Zoom will re-enable auto focus and iris after manual adjustment
32 preset positions.
2 sequential preset tours of preset positions 1 - 16, tour 1 high speed and tour 2 slow speed. The dwell time
is fixed at 10 seconds per preset position. Preset positions can be removed from the tours.
All 32 privacy zones can be programmed and disabled if required.
Advanced Function TX1500 Procedure
180 degree pan flip (U turn)
1 #
Program a privacy zone
2 # followed by
PROGRAM 1-32 PRESET
Clear a privacy zone
3 # followed by
PROGRAM 1-32 PRESET
Add preset position to the tours
Programming a preset position adds the preset into
the tour. (1 – 16 only)
Remove a preset from the tours
PROGRAM 50 PRESET followed by
1-16 PRESET
Start preset tour 1 – high speed 1 PATROL (max speed with 10 second dwell)
Start preset tour 2 – slow speed 2 PATROL (speed 32 with 10 second dwell)
Set autoflip mode
PROGRAM 51 PRESET followed by
1 PRESET = autoflip OFF
2 PRESET = ON tilt at down limit
3 PRESET = ON when at limit
Set Video Gain/Lift and Sync timing
PROGRAM 52 PRESET followed by
IRIS CLOSE/OPEN to increase/decrease GAIN
FOCUS NEAR/FAR to increase/decrease LIFT
ZOOM IN/OUT to advance/retard timing
Move joystick when finished.
Set IR Filter mode
PROGRAM 53 PRESET followed by
1 PRESET = mono mode/auto off
2 PRESET = colour mode/auto off
3 PRESET = auto/kill colour
4 PRESET = auto/don’t kill colour
Set Home functions
(Revised in V16 software)
PROGRAM 54 PRESET followed by
1-5 PRESET = Function
(1=enable,2=disable,3=preset 1,4=tour1,5=mimic 1)
1-60 PRESET = timeout in minutes
Unit Reset.
This simulates powering the dome off/on
PROGRAM 55 PRESET followed by
PROGRAM 55 PRESET
Preset Tour Definition
Example to program tour 1
Step 1 – define tour. PROGRAM 56 PRESET
Step 2 – tour 1 or 2. 1 PRESET
Step 3 – 4 presets for each preset point
1 PRESET (point 1)
1 PRESET (PRESET 1)
64 PRESET (max speed)
10 PRESET (10 seconds dwell)
PROGRAM 56 PRESET (start definition)
1 or 2 PRESET – Tour number
1 – 64 PRESET (tour point number)
1 – 32 PRESET (preset number)
1 – 64 PRESET (speed)
1 – 64 PRESET (dwell in seconds
repeated for each point apart from last
Connect dome D+ to BBV 1-2-1 converter TA
and dome D- to BBV 1-2-1 converter TB.
Set the dome address using the DIL switch to match the number of
the camera input of the TX1500.
SW4