Installation guide

BBV_1-2-1 _Protocol_converter_manual_V41_November_2013 Page 16 / 40
Chugai/Ganz ZC-S122/123 – Fixed at 9600,E,8,1 from BBV and Pelco D/P
telemetry only
Function TX1500 Procedure Pelco Procedure
Menu ON/OFF
1 #
Go to Preset 61
SET (whilst in menu)
2 #
Go to Preset 62
CLR (whilst in menu)
3 #
Go to Preset 63
PRESET SEQUENCE 1 PATROL Go to Preset 66
PLAYBACK TRACE 2 PATROL Go to Preset 67
AUTOPAN AUTOPAN Go to Preset 68
AUX 1 OUTPUT ON/OFF LIGHTS 1 AUX
AUX 2 OUTPUT ON/OFF WIPER 2 AUX
Notes:
Connect dome A/+ (pin 1, BROWN) to the BBV 1-2-1 converter TA and dome B/- to the BBV 1-2-1
converter TB.
Each dome must be set to 9600 Baud with switch 5 OFF, switch 6 ON. Set the dome address using the
dome rotary switches to match the number of the camera input of the TX1500. Ensure that domes at the
end of the RS485 run are terminated by turning switch 8 ON and the intermediate domes have the switch 8
OFF.
A total of up to 96 domes are supported with a maximum of 32 domes per star output.
Menu access:
Press 1# will toggle the Menu display ON/OFF.
Whilst the menu is displayed the joystick is used to navigate.
2# is used as SET to access a menu option and
3# is used as CLR to go back.
Addition functions are available for the currently displayed dome:
AUTOPAN is started by pressing the AUTOPAN key.
PRESET SEQUENCE is started by pressing 1 PATROL.
TRACE playback is started by preceding 2 PATROL
The protocol 1-2-1 converter can directly access preset 1 – 64 by pressing the preset number followed by
the PRESET key.
To program a preset position, press PROGRAM followed by the preset number and the PRESET key. See
the TX1500 manual for detailed information.
SW4