Installation guide

BBV_1-2-1 _Protocol_converter_manual_V41_November_2013 Page 18 / 40
COP PELCO D or PELCO P from BBV and Pelco D/P telemetry only
Connect the twisted pair as follows:
dome RS485+ (ORANGE) to BBV 1-2-1 converter TA
dome RS485- (YELLOW) to BBV 1-2-1 converter TB
Baud Rate SW4/7
2400 OFF (default)
9600 ON
Protocol SW4/8
PELCO D OFF (default)
PELCO P ON
Set the dome for protocol and baud rate. The default is 2400 baud and Pelco D telemetry.
Set the dome address to match the number of the camera input of the matrix.
The following functionality is provided:
Variable speed Pan/Tilt
Zoom/Focus/Iris
63 preset positions.
Menu access and navigation
Pattern record and playback+
Preset patrol 1 and 2 playback
Additional Dome features
Dome Function TX1000 Keystroke TX1500 Keystroke Pelco Procedure
DISPLAY DOME MENU
hold # and tap WASH
and navigate using the
joystick and IRIS keys
1 # and navigate
using the joystick
and IRIS keys
Go to Preset 61
PATTERN RECORD
START
hold # and tap
AUTOPAN then use
joystick to move dome
around required scenes.
3 # then use joystick
to move dome
around the required
scenes.
Go to Preset 63
PATTERN RECORD STOP hold # and tap LIGHTS
4 #
Go to Preset 64
PATTERN PLAYBACK
AUTOPAN AUTOPAN
Go to Preset 68
PATROL 1 PLAYBACK hold PATROL and tap 1
1 PATROL
Go to Preset 66
PATROL 2 PLAYBACK hold PATROL and tap 2
2 PATROL
Go to Preset 67
DENNARD 20xx – Fixed at 9600,N,8,1 (adjust SW3 to suit input protocol)
Connect the twisted pair as follows:
dome RS485+ (YELLOW) to BBV 1-2-1 converter TA
dome RS485- (GREEN) to BBV 1-2-1 converter TB
To enter when in menu send a ‘GOTO PRESET 1’
Function TX1500 Procedure Pelco & Mark
Mercer Procedure
Molynx
Display Dome Menu
1 #
Go to Preset 61 Cam on then Prog preset 1
Display User Menu
2 #
Go to Preset 62 Cam on then Prog preset 2
Display Technicians Menu
3 #
Go to Preset 63 Cam on then Prog preset 3
Start current dome’s Sequence 001
1 PATROL
Go to Preset 66 Cam on then Goto preset 5
Start ALL DOMES Sequence 001
2 PATROL
Go to Preset 67 Cam on then Goto preset 6
Navigate through the dome menu using pan/tilt and issue GOTO PRESET 1 to select current line.
SW4
SW4
SW4/7 Baud
SW4/8 Protocol