Installation guide

BBV_1-2-1 _Protocol_converter_manual_V41_November_2013 Page 19 / 40
DM DTMF RECEIVERS USING TAD3 from BBV and Pelco D/P telemetry only.
SEND CAMERA SELECTS BEFORE EVERY MOVEMENT COMMAND (useful for noisy
links to ensure that the correct camera is controlled although this provides increased
control delay)
- OR -
ONLY SEND CAMERA SELECT WHEN CAMERA CHANGES
(This is the normal method and gives improved control for most applications)
Notes
The DM TAD3 must be sourced from DM and fitted with special software TTT1_0 in IC3 position and
ensure that the following configuration links are fitted. If the link is multi pins then only fit links that are
shown and not fitted if not shown
J2/5-6 J4/1-2 J5/2-3 J6/2-3 J7/1-2 J9 – fitted
Connect from the
1-2-1 CONVERTER TAD3 CBUS DIN SOCKET
TA pin 2
TB pin 1
GROUND pin 3
DTMF from the TAD3 to DTMF receivers use the TONE or AUDIO connector as required.
In addition to the normal manual pan/tilt/zoom commands the following are also supported.
WASH = AUX 1
WIPER = AUX 2
LIGHTS = AUX 3
AUTOPAN = *858001 START, *858000 STOP
PATROL = *854001 START, *854000 STOP
SW4
SW4