Installation guide

BBV_1-2-1 _Protocol_converter_manual_V41_November_2013 Page 20 / 40
FORWARD VISION MIC-1300/400 from BBV and Pelco D/P telemetry only
Connect the twisted pair as follows:
Dome RX A (YELLOW) to BBV 1-2-1 converter TB (A & B swapped)
Dome RX B (WHITE) to BBV 1-2-1 converter TA
Set the dome address to match the number of the camera input of the matrix.
The following functionality is provided:
Variable speed Pan/Tilt
Zoom/Focus/Iris
64 preset positions.
Patrol (sequence) record. 8 positions of presets 1 – 16
Autopan
Additional dome features
Dome Function TX1000 Keystroke TX1500 Keystroke Pelco Procedure
SPECIAL PROGRAMMING
(see below)
hold # and tap WASH 1 #
Go to Preset 61
DIGITAL ZOOM ON/OFF hold # and tap WIPE 2 #. Go to Preset 62
MANUAL/AUTO
EXPOSURE
hold # and tap
AUTOPAN
3 #
Go to Preset 63
IR FILTER IN/OUT hold # and tap LIGHTS 4 # Go to Preset 64
ENABLE ALL SCENE
Hold # and tap WASH,
PROGRAM 1, 1
1 # PROGRAM 1
PRESET
Go to Preset 61, Program 1
Preset
DISABLE ALL SCENE
Hold # and tap WASH,
PROGRAM 1, 2
1 # PROGRAM 2
PRESET
Go to Preset 61, Program 2
Preset
TOGGLE CURSOR
ON/OFF
Hold # and tap WASH,
PROGRAM 1, 3
1 # PROGRAM 3
PRESET
Go to Preset 61, Program 3
Preset
ENABLE AROUND
CURSOR
Hold # and tap WASH,
PROGRAM 1, 4
1 # PROGRAM 4
PRESET
Go to Preset 61, Program 4
Preset
DISABLE AROUND
CURSOR
Hold # and tap WASH,
PROGRAM 1, 5
1 # PROGRAM 5
PRESET
Go to Preset 61, Program 5
Preset
PROGRAM PRESET PATROL
The 1-2-1 CONVERTER supports a single preset patrol per dome with a programmable dwell time and up
to 8 preset positions. Please ensure that you program the preset positions first using the normal procedure.
The keystrokes used will depend on the controller used. The TX1000 and TX1500 procedures are shown
below.
TX1000
a. Hold # and tap WASH, then Hold PATROL and tap 1 (patrol programming mode)
b. Hold PRESET and tap 1 – 16 (dwell time 1 – 16 seconds)
c. Hold PRESET and tap 1 – 16 (first preset position)
d. repeat step C for up to 8 preset positions total
e. Hold PATROL and tap 1 (save the dome patrol)
TX1500
a. 1 # then 1 PATROL (patrol programming mode)
b. 1 – 64 PRESET (dwell time 1 – 64 seconds)
c. 1 – 64 PRESET (first preset position)
d. repeat step C for up to 8 preset positions in total
e. 1 PATROL (save the dome patrol)
Pelco
a. 61 Preset then 66 Preset (patrol programming mode)
b. 1 – 64 PRESET (dwell time 1 – 64 seconds)
c. 1 – 64 PRESET (first preset position)
d. repeat step C for up to 8 preset positions in total
e. 66 Preset (save the dome patrol)
Continued on page 21
SW4