Installation guide

BBV_1-2-1 _Protocol_converter_manual_V41_November_2013 Page 24 / 40
Meyertech ZVR-510 receiver with VICTA protocol from BBV and Pelco D/P
telemetry only.
Connect receiver 422 RX+ to BBV 1-2-1 converter TA and 422 RX- to BBV 1-2-1 converter TB.
Set the receiver address to match the number of the camera input of the matrix.
The following functionality is provided.
Variable speed Pan/Tilt – 8 speeds
Zoom/Focus
WASH, WIPE, LIGHTS auxiliary outputs
32 preset positions.
Menu access and navigation
The Meyertech protocol supports 8 speeds for pan and tilt. If the head is to pan and tilt simultaneously then
the same speed is used for both axis. For example if the head is moving left at say speed 4 and then the
joystick is moved up the head will now move left at the new tilt speed. This is not a problem with the 1-2-1
converter but a limitation of the Meyertech protocol.
Receiver Menu Access and navigation.
Receiver Function
TX1500 Keystroke Pelco Procedure
RECEIVER MENU ON
Once the receiver menu is displayed the
joystick is used to navigate the cursor.
1 #
Go to Preset 61
MENU ENTER
Select the flashing item
2 #
Go to Preset 62
MENU TOGGLE ITEM
Used to cycle options displayed in [ ]
brackets.
3 #
Go to Preset 63
EXIT MENU MODE – ALLOW PTZ
This must be sent when the menu has been
exited to allow normal pan/tilt control with
the joystick.
4 #
Go to Preset 64
ENTER NUMBERS 0 – 9
1 – 9 PRESET = number 1 – 9
10 PRESET = number 0
1 – 9 PRESET = number 1 – 9
10 PRESET = number 0
AUX A1 ON/OFF
GOTO PRESET 81 /
GOTO PRESET 82
1 AUX ON/OFF
SW4